1. No category

Thank you for your purchase of an
ecostream system.
ecostream System
Cartridge Change
Guide
1.After removing the water bottle from the cooler, remove the
upper front cover of the cooler.
2.Remove the ecostream funnel assembly by releasing the feed
For optimal performance, please
follow the instructions in this guide.
Using an ecostream system outside
of these operating parameters may
result in poor performance and
could invalidate the warranty.
3.Remove the chiller cartridge by releasing the feed pipe from the
cold (blue) tap clamp and lifting out of the cooler.
4.Assemble the cold feed pipe to the chiller cartridge chassis.
pipe from the ambient (white) tap clamp, depress the lock clip
front centre and lift the funnel assembly from the top of the
cooler. The funnel assembly can be either sanitized or replaced.
For more information on ICON
products, please visit our website
www.icontechnologysystems.com
Icon Technology Systems Limited, The Court House, Altrincham, WA14 1DU, UK
PO Box 801208, 5330 Brookstone Drive, NW STE 250, Acworth, GA 30101, USA
ecostream System
Cartridge Change
Guide continued
5.Install the new chiller
6.Fit the cold feed pipe to the
cartridge into the cooler
chiller unit – please note that
the silicon membrane should
be at the top left.
cold (blue) tap clamp.
8.Fit the ambient feed pipe to the ambient (white) tap clamp and the
waste pipe to the receptor. Ensure that the funnel spike is aligned
to the chiller cartridge silicon membrane.
9.Push down on the funnel top to locate into place fully, piercing
7.To replace the funnel, align the arrow and clip to the front and push
into the cooler top, ensuring the ambient feed pipe and waste pipe
also go through the cooler top.
the spike through the silicon membrane (this will open all the air
tack and water ways). Finally, replace the front upper cover of the
cooler and install a new water bottle. Ensure you test both cold and
ambient water feeds.
For more information on ICON
products, please visit our website
www.icontechnologysystems.com
Icon Technology Systems Limited, The Court House, Altrincham, WA14 1DU, UK
PO Box 801208, 5330 Brookstone Drive, NW STE 250, Acworth, GA 30101, USA