Standard wall sleeve Cement coated wall sleeve ZVR
Standard wall sleeve Cement coated wall sleeve ZVR KIWA tested by n test io construct Article code: ZVR (D)/X Features and technical data: • application: all load cases according to DIN 18195 Part 4 waterproof concrete stress class 1 • suitable for any type of wall • watertight up to 5 bar • extremely lightweight plastic component • homogeneous bond with the masonry thanks to its special coating • suitable for retrofitting in cutouts and/or rectangular openings • sealed ready for installation • break-resistant, inherently stable • easy on-site adjustment to required wall thickness • certified by KIWA construction test • pipe diameters from 80 up to 300 mm The wall sleeve with special coating. The new cement coated wall sleeve consists of a break-resistant, inherently stable plastic wall sleeve with a special coating. This coating bonds perfectly to the wall sleeve, adheres homogeneously with the concrete and yet still cancels out any fluctuations in temperature. The cement coated wall sleeve can either be set in concrete, walled in, or cast in a wall opening with mortar. The wall sleeve is watertight at pressures up to 5 bar – as certified by the KIWA construction test – and, in conjunction with our press seals, produces a completely watertight seal between the pipe or cables being laid inside the wall sleeve. cablepipebuildingentry+ Wall sleeve ID Wall sleeve OD Article code 0 – 56 mm 95 mm ZVR 80/X 0 – 63 mm 0 – 76 mm 115 mm ZVR 100/X 125 mm 63 – 90 mm 0 – 101 mm 142 mm ZVR 125/X 150 mm 90 – 112 mm 0 – 125 mm 167 mm ZVR 150/X 200 mm 110 – 162 mm 0 – 171 mm 219 mm ZVR 200/X 250 mm 160 – 210 mm 0 – 214 mm 269 mm ZVR 250/X 300 mm 200 – 225 mm 0 – 250 mm 321 mm Optimal application range OD Max. possible application range OD * 80 mm 0 – 50 mm 100 mm ZVR 300/X X = wall thickness in mm For lengths > 500 mm the cement bond sleeve is coated on both sides at a width of 250 mm. *Sizes refer to possible OD of media pipe; depending on technical possibility a standard press seal or a individual press seal is used. Accessories (not included in scope of delivery) Standard press seal – is the perfect seal for pipes being newly installed or which have already been laid in core drills or wall sleeves up to diam. 500 mm. Hauff-Technik GmbH & Co. KG Robert-Bosch-Straße 9 89568 Hermaringen, GERMANY Individual press seal – in a closed design is tailor made to meet your requirements and forms the perfect seal for newly installed pipes with diam. 80 up to 1,400 mm. Tel. +49 7322 1333-0 Fax +49 7322 1333-999 offi[email protected] www.hauff-technik.de The information in this publication represents our current state of technical knowledge and experience. However, given the multitude of possible influences affecting the processing and use of our products, this information does not exempt processors and users from running their own tests and trials. We will replace any parts that cannot be used due to defective materials. We do not replace parts for defects caused due to transport, storage or faulty installation and the consequences thereof. All information without guarantee. Media pipe zement-verbund-rohr_zvr_en_140401 Cement coated wall sleeve ZVR Technical data
© Copyright 2024