1. No category

SHELL AND TUBE HEAT EXCHANGERS mixing & heat transfer Double Tube Sheets for cGMP and High Purity Applications Problem In a typical shell and tube heat exchanger, any leak in the tube sheet will cause immediate cross­ contamination between the process and cooling liquid. tube side seal
shell side seal Solution The double tube sheet design with an intervening safety chamber prevents contamination of product and cooling liquid under all circumstances. In case of a leaking tube gasket, the product or cooling liquid runs into the safety chamber and through the purge valve. The leakage is detected immediately. The construction enables the use of various materials on the tube and shell side to meet any specific requirements. An additional feature is the installation of a product drain through the edge of the tube sheet, especially useful for complete recovery of shell­side product in a vertical installation Advantages §Absolute cross­contamination proof design, even with vacuum in the shell or tube side. Shell and tube heat exchanger with double tube sheet §Custom designs use cGMP materials to meet specific applications, such as glass, SiC, glass­lined steel, stainless steel, PTFE § Minimal product holdup eases cleaning and prevents product losses §Meets CIP and SIP specifications M4.400 05/09
244 SHEFFIELD STREET
MOUNTAINSIDE NJ 07092
FAX 908-889-4960
908-317-2585
WWW.DDPSINC.COM
9110 FORSYTH PARK DRIVE
CHARLOTTE NC 28273
EMAIL [email protected]
FAX 908-889 4960
Copyright © De Dietrich Process Systems, Inc. All rights reserved. The information contained in this brochure is believed to be reliable general guidelines for consideration of the products and services described herein. The information is general in nature and should not be considered applicable to any specific process or application. De Dietrich Process Systems, Inc. expressly disclaims any warranty, expressed or implied of fitness for any specific purpose in connection with the information contained herein.