Extend Rust Treatment ® Kills old rust. Prevents new rust for years. Stop Rust Dead Brush or spray Extend® onto any wire-brushed or sanded surface. Leave on some rust. Extend® goes on white. Turns black in 10 minutes. 6 Months: Extend® continues to prevent rust even with constant water/salt spray contact. 1 Year: Even under continuous high humidity Extend® still looks new. 18 months later: Extend® still keeps old rust from coming back. Prevents new rust from starting. PRODUCT BENEFITS •Easy to use. No Sandblasting. Just wire-brush or sand to remove heavy layers of rust, clean off any oil, dirt or grease. Brush or spray Extend® Rust Treatment on surface. It does the rest. •Converts and primes in one operation. Three coats are recommended for maximum durability. •Replaces conventional primer for most industrial finish paints. •Works on damp, rusty metal. •Non-flammable and low toxicity. Don’t just treat rust. Kill it with Extend® Extend ® No more scraping or sandblasting. No more primers, acid penetrants or conversion washes. Rust Treatment Extend® kills old rust and prevents new rust quickly and easily. It is a fast drying, latex coating that is applied to rusted metal to stop rust, protect the surface and act as a primer for the finish coat. TYPICAL APPLICATIONS Extend® Rust Treatment is used on rusted steel to stop rust, coat surface, and as a primer for various covering paints on: • Pipes, valves, fittings in refineries, tankers, power plants, domestic and commercial heating/cooling plants • Truck trailers, storage tanks • Fences, guardrails, conveyors, supports • Overhead cranes, booms, floor gratings, ductwork Before • Outdoor advertising sign supports/frames, municipal and highway signposts and frames • Bulkheads, overheads, decks, hatch covers, stacks on ships (topcoat with appropriate marine paint) • Agricultural equipment, harvesters, plows, discs, tractors, corn pickers, etc. • Snow removal equipment in highway department maintenance yards Performance Characteristics Extend® Rust Treatment’s unique capability makes it ideal for maintenance use in applications where sandblasting is not practical or economical. Extend® gives a quality level of conversion and protection, especially when followed by conventional prime and/or finish coats. Most finish paints will not require any additional primer. However, light color latex and metal filled paints require a solvent base primer on top of Extend® Rust Treatment coating before finish application. Extend® was tested for 100 hours at 95°F, condensing humidity, salt spray (ASTM B117-73), and satisfactory performance was obtained. This test is equivalent to 2 years of outdoor exposure. Protection is enhanced with Extend® plus an overcoat such as epoxy, alkyd, urethane, or chlorinated rubber. • Paper mills, chemical plants, steel mills, utilities for maintenance of pipes, tanks, support steel, valves • Protect castings and stampings before final machining NOTE: Not recommended where total immersion in any liquid is required. Henkel Corporation Engineering Adhesives www.henkelna.com/mro www.loctite.com After Extend Rust Treatment and fresh paint Item # 30539 75430 75448 75465 IDH # 234928 234981 160802 234984 PACKAGE SIZE 10.25 oz. net wt. aerosol 1 quart bottle 1 gallon bottle 5 gallon pail U.S.A. Canada Henkel Corporation Engineering Adhesives 1001 Trout Brook Crossing Rocky Hill, Connecticut 06067 Tel: 1.800.LOCTITE (1.800.562.8483) Tel: 860.571.5100 Fax: 860.571.5465 Henkel Canada Corporation Engineering Adhesives 2225 Meadowpine Blvd. Mississauga, Ontario L5N 7P2 Tel: 1.800.263.5043 (within Canada) Tel: 905.814.6511 Fax: 905.814.5391 ® and ™ designate trademarks of Henkel Corporation or its Affiliates. ® = registered in the U.S. Patent and Trademark Office. © Henkel Corporation, 2009. All rights reserved. 5833/LT-5526 (6/09)