Bluetooth® User Manual Know your headphone: Bluetooth® On/Off Instructions: 1. Turn on: In the state of power off, press and hold the power button for 1s, the headset will send out two "dodo" prompt tones; hold it for 4s, blue LED light will be on and flashing. 2. Turn off: In the state of power on, press the power key and hold it for 5s, until the red LED light is flashing three times. There will be three "dodo" voices from loud to low. Function Description Wired headphone This Bluetooth headphone can be as the wired headphone, just simply attached 3.5mm audio cable. In the state of power off, it can be used as the wired stereo headphone by inserting the 3.5mm audio cable. Please adjust the volume of sound sources when it is as the wired headphone. At this case, the volume control of the headphone cannot be workable. HOW TO CONNECT YOUR BLUETOOTH HEADSET IMPORTANT—PLEASE READ THIS FIRST BEFORE USING YOUR HEADSET ® Pairing Your Bluetooth Headset Easy as1-2-3 IMPORTANT- Be sure your phone or mobile device is Bluetooth ® capable. Check the Owner’s Manual or manufacturer’s website to verify your phone or mobile has this feature. Now, let’s get started: ® 1. Make sure your Bluetooth function on your phone has been turned “ON”. This can usually be done by going to SETTINGS} BLUETOOTH or CONNECTIONS}”Turn On”. Make sure the Headset is charged and turned “OFF”. (See Headset Owner’s Manual for initial and subsequent charging instructions) 2. Next, on the headset, Press and hold the Power button for 5 seconds until the Indicator Light flashes alternating “Red – Blue – Red – Blue” to enter the pairing mode. NOTE: If your phone or mobile device exits PAIRING mode before you complete the PAIRING process, you must repeat the Headset’s “Press and hold the Function button for 5 seconds” step until the Headset’s Indicator Light flashes alternating “Red-Blue-Red-Blue” again to re-enter the PAIRING mode. ® 3. On your phone or mobile device, locate the Bluetooth MENU and select the ADD NEW DEVICE or SEARCH function: ® a. Once you are in PAIRING mode, you must choose and confirm the Headset as your Bluetooth paired device. Your phone or mobile device should first “locate” your Headset and then ask you if this is the device you want to pair your phone with. Answer”Yes”. ( Device will show up as Replay Audio) b. Your phone or mobile device should now prompt you to key in a headset “PASSCODE”. c. Key in “0000”. (Some phones will not require a passcode) d. Once you have keyed in the PASSCODE-your phone or mobile device should prompt you to press “YES” or another key to confirm the code you just entered.(please see your phone or mobile device’s Owner’s manual for additional information) After you have successfully paired your Headset with your phone or mobile device, the Indicator Light on the headset will flash the Bluetooth light ONLY, the Headset should now be in STANDBY mode. ® The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc.
© Copyright 2024