1. No category

Guide Vane Actuating Unit
Retrofit for isotherm turbocompressors
Guide Vane Actuating Unit
Optimised for maximum reliability
Horizontal installation of the guide vane actuating unit consisting of actuator and positioner
Assembly of guide vane actuating unit
As the previous actuating units for the guide vane adjustment at RIK turbocompressors did not prove the expected long-term reliability, MAN PrimeServ
developed a new actuator with an electro-pneumatic positioning unit. The new
guide vane actuating unit has been installed on all RIK turbocompressors since
2005. It is operating fully satisfactorily in more than 150 field installations and
recommended as a “plug & play” solution to all customers with previous installations of RIK turbocompressors.
1
4-20 mA
4 mA
1
2
3
4
5
6
5
Instr.
air
supply
2
3
Piston actuator
Shut-off valve
Air filter
Air pressure regulator
E/P positioner
Position transmitter
4
6
Control signal 4-20 mA
Horizontal installation of the guide vane actuating
unit consisting of actuator and positioner
4-20 mA
Schematic drawing of guide vane actuating unit
Challenge
recommended to all customers who had RIK turbo-
The operation of adjustable guide vanes in a turbo-
compressors installed up to 2004.
compressor in general requires a reliable and accurate
drive system. Easy installation and configuration, as
Advantages
well as low energy consumption and low maintenance
nreliable
costs are state-of-the-art requirements. As the pre-
harsh environmental conditions
vious solution for RIK turbocompressors did not prove
n“Plug
the expected long-term reliability, MAN PrimeServ
neasy
developed a new guide vane actuating unit.
neconomic
and robust design for operation in
& play” retrofit to existing installations
installation and configuration
nsuitable
replacement remedy and quick delivery
for all adjustable guide vanes at the inlet Solution
position and at intermediate compressor stages
The new guide vane actuating unit of compact design
nminimised
process variability due to excellent consists of a linear pneumatic actuator and intelligent
dynamic and static control performance,
positioner. It is specifically designed for MAN turbo-
high speed of response and accurate internal machines and ensures a reliable and trouble-free
measurements
guide vane adjustment for all isotherm turbocompres-
nvane
position indicator on positioner allows
sors type RIK. The new design has already proven its
operator to check guide vane position easily
reliability in more than 150 field installations since
nproximity
2005 where it operates fully satisfactorily.
sensors (standard) and mechanical limit switches (optional)
nall
moving parts are enclosed for maximum
The unit is designed to replace former types of guide
safety and reliability
vane actuating units on isotherm turbocompressors
nlow
energy and instrument air consumption
type RIK very easily by “plug & play”. It is therefore
nlow
maintenance costs
24/7 Hotline: +49 208 692 9000
MAN PrimeServ – a service brand of MAN Diesel & Turbo
All data provided in this document is non-binding. This data serves informational purposes only and is especially not guaranteed in any way. Depending on the subsequent specific individual
projects, the relevant data may be subject to changes and will be assessed and determined individually for each project. This will depend on the particular characteristics of each individual
project, especially specific site and operational conditions · Copyright © MAN Diesel & Turbo · D02081035EN Printed in Germany GMC-OBH06100.5
MAN Diesel & Turbo Schweiz
8005 Zurich, Switzerland
Phone+41 44 278 2211
Fax +41 44 278 2261
[email protected]
www.mandieselturbo.com