How to use OIB 1 May 2013 www.centumlearning.com LED Indicator – what the icons mean, state and description The router operates on the HSPA+/HSUPA/HSDPA/WCDMA network and GSM/GPRS/EDGE/3.75G network and supports voice and data service www.centumlearning.com LED Indicator Indicator Icon State ON 1 WAN signal strength Blinking indication OFF Blue 2 Network mode indication Red OFF ON 3 WAN connection status Blinking indication OFF Off 4 Phone status indication On Off 5 Phone status Indication Blinking On Off 6 WiFi indication Blinking ON 7 Power indication OFF Description Signal strength is very good or good Signal strength is weak No signal Registered to 3G network Registered to 2G network Not Registered WAN connection established (PDP activated) WAN connection establishing (PDP activating) WAN connection not established (PDP not activated) PSTN not connected PSTN connected or calling via PSTN Local phone hang up Phone picked up, ringing or network CS registering In calling. WLAN shut down WLAN working normally with data transmission External power supply works normally. External power supply is disconnected or power off www.centumlearning.com Interface Description 1. Phone: Standard RJ11 connector for Telephone 2. PSTN: Standard RJ11 connector for PSTN 3. WAN/LAN: Ethernet connections to internet. In 3G Gateway mode, it is LAN connector. In Cable broadband and Bridge mode, it is WAN connector 4. LAN1~LAN3: Ethernet connections to computer www.centumlearning.com Interface Description 5. 6. 7. 8. Reset: Reset button ON/OFF: Turn the router ON or OFF ANT: Connect to external antenna PRESS ANT ON: To switch between internal antenna and external antenna modes. Press-down means to use internal antenna, promptup means to use external antenna. It’s in press down mode as default, only prompt up this button when you connect to an external www.centumlearning.com antenna How to use OIB 1. Insert SIM card (provisioned with data and voice services) on the router 2. Switch it on, on the on off button 3. Signals will be emitted from the Led indicator to show if the signal is good or poor To make voice calls: To access data: 1. Connect RJ11 wire to the router 2. Dial number on the handset/phone Connect via LAN Connect to wireless 1. Connect to wireless 2. Deactivate proxy 3. Confirm signals from the led indicator 1. Connect WAN/LAN with an Ethernet cable (RJ45) 2. Deactivate proxy 3. Confirm signals from the led indicator www.centumlearning.com