1. No category

How to update:
SDF-310
1.
Turn on the equipment and input the SD card.
2.
Press MENU.
3.
Select ETC - ENTER.
4.
Select Version - ENTER.
5.
When the small window is opened, Press ENTER.
*Warning: Do not turn the equipment power off before finish the update.
6.
Check the message “Status: Update completed…” after finish.
7.
Remove the SD card and press ENTER then the equipment is rebooted.
How to update:
N560/NF560/F560/N700/NF700/F700/AIS-50N

Backup the data before start the update.
1.
Turn on the equipment first and input the SD card.
2.
Press and hold MENU button.
3.
Select System Configuration.
4.
Go to System Configuration – About. Press MENU button and check the Option window
is opened like below image.
5.
Select S/W upgrade and press ENTER.
6.
Press ENTER at the S/W upgrade page
7.
Upgrade will be started automatically.
*Warning: Do not turn the equipment power off before finish the update.
8.
Check the message “Status: Update completed…” after finish.
9.
Remove the SD card and turn off the power.
Method of Software upgrade for N100A/NF100A/N120A/NF120A.

Register the data in SD-card before upgrade.
1.
Insert SD card to the equipment when the power is on.
2.
Press “menu”.
3.
Press “System/software upgrade”
4.
When the following screen appear, press “enter”
5.
When press “enter”, upgrade of this software is in progress.
* Attention : Don’t power-off prior to the completion of upgrade.
6.
After the completion of upgrade, the message of “Status Update completed” is appear.
7.
Get out SD card from SD slot and power-off.
How to update:
F430/N430/NF430/N100/NF100/N120/NF120

Warning: Before start the upgrade, do backup the data.
1.
Turn on the equipment and input the SD card.
2.
Press and hold the MENU button.
3.
Select System Configuration.
4.
Go to System Configuration – About. Press MENU button and check the small window
is opened like below image.
5.
Select S/W upgrade and press ENTER.
6.
Press ENTER at the status like above image.
7.
Upgrade will be started automatically.
*Warning: Do not turn the equipment power off before finish the update.
8.
Check the message “Status: Update completed…” after finish.
9.
Remove the SD card and turn off the power.
Upgrade method.
NAVIS800S/800FS/NAVIS5100A/FA/NAVIS3800/F (same)

Before upgrade, essentially save the data in SD card.
1.
Insert SD card in power on of equipment
2.
Push the button of “menu”.
3.
자료에서 입력, 프로그램개정에서 입력키를 누른다. [아래화면참조]
4.
프로그램 개정에서 입력키를 누르면 아래와 같이 업그레이드 화면이 뜬다.
5.
Above upgrade screen appear and push “enter” and then the upgrade is in process.
Attention :
Before the completion of upgrade, don’t power off the equipment.
6.
After the completion of upgrade, you can find above message
7.
After plug out the SD card, you can power off and on