A professional application of Nyalic ® is ideal for restoring, protecting and increasing the life of your equipment. Call: 770-690-1480 How to Clean and Maintain a NYALIC® Coating • The First 2-Weeks, Do not wash a Nyalic coated surface for the first two (2) weeks. This allows the product to properly cure. • NEVER use a wax, polish or abrasive cleaners on a Nyalic coated finish, these products may dull the coating. • After the two (2) week cure period, a Nyalic coated surface is best cleaned using HBI’s Right Rinse™ and a soft bristle brush. Right Rinse can be purchased at our on-line store at www.nyalic.com. • It is not recommended to use compressed air to blow down a Nyalic-coated surface. This action can be the equivalent of media-blasting the surface. • NEVER USE ANY SOLVENT-BASED CLEANERS, ESPECIALLY DEGREASERS, ON ANY SURFACE THAT HAS BEEN COATED WITH NYALIC. SOLVENT-BASED CLEANERS WILL RUIN THE NYALIC FINISH. • Fuel or solvent spills should be immediately rinsed off with clean water and dried. Fuel or solvent spills that are left to dry may over time need to be touched-up using the Nyalic Touch-up Kit available at our on-line store at www.Nyalic.com. • It is not recommended to use high-pressure washers to clean a Nyalic-coated surface; doing so can lift the coating or paint. • Scrapes, severe scratches and other damage of a Nyalic® coating can easily be repaired with the Nyalic Touch-up Kit that includes Nyalic® in aerosol. Nyalic is self-leveling making repairs seamless with the existing coating. The touch-up kit is available at our on-line store at www.Nyalic.com. Nyalic®…clearly better protection. ©2012 HBI, Inc. All rights reserved. NYALIC is a registered trademark of HBI, Inc.