THOMPSON RETRACTOR USER MANUAL
Infinite Height Rail Clamp
1.
1. Secure the Infinite Height Rail Clamp to the table rail over the
sterile drape on either side of the table.
CAUTION: If the patient is obese, avoid compressing the ulnar
nerve. When necessary, use a wider OR table or add 2 1/2" to
the width of the table by using our Rail Extender (41917)
SECURE
2.
2. Start with height in tallest setting. Adjust height by
loosening joint.
SLIDE DOWN
ROTATE
TO LOOSEN
JOINT
Slide the post down to the desired height and secure
the setting. Tighten joint completely to lock.
ROTATE
TO LOCK
JOINT
3. Add frame components to rail clamp joint(s).
Do not attempt to adjust rail clamp height with frame components attached unless supporting the weight of
the frame components with a hand. The post will not slide easily during height adjustments if this is not done.
Made in the USA
EC
10170 East Cherry Bend Road
Traverse City, Michigan 49684
phone: 231.922.0177
fax: 231.922.0174
thompsonsurgical.com
© 2014 Thompson Surgical Instruments, Inc. Traverse City, Michigan.
® S-Lock and the T-Circle Logomark are Registered Trademarks of Thompson Surgical Instruments, Inc.
Patents: US4971038, US5025780, US5888197, US5897087, US5902233, US5984865, US6017008, US6033363, US6416465,
US6511423, US7338442, US7749163, US8257255, US8360971, US8617064. Other patents pending.
REP
Emergo Europe
Molenstraat 15
2513 BH, The Hague
THE NETHERLANDS
0297
Rev A
060414
dc ihrcum0614