1. No category

Data sheet | DPBIT34 | 1-channel PT100 sensor amplifier | 2-wire bus
Product description
DPBIT34 is a PT100 amplifier component for interfacing a standard PT100
temperature sensor to the Bitlink 2-wire
bus system. The component has a 12 bit
A/D converter and interfaces to sensors
following the IEC751 standard. DPBIT34
uses a 2-wire connection from sensor
to amplifier, with a maximum allowable
cable length of 2m (6 ft).
The Bitlink bus and the sensor are not
electrically isolated. The point address is
selectable from 0 to 255.
testbillede!
This component is available in 8 versions:
version A has an RJ12 connector, version
B a terminal block. 4 diff. temp. variables...
which?!
Power
supply
1
PT100
sensor
12 bit ADC
Bitlink cable
Bitlink
controller
Bitlink
transceiver
2
DPBIT34
Point address
Technical specification
Component type:
Sensor type:
PT100 / RTD amplifier
PT100
Ambient temperature: Relative humidity:
0-50°C ( 32-122°F )
0-90%, non-condensing
Sensor coefficient:
Sensor standard:
Update rate:
Resolution:
Factory calibration:
Linearity:
0.00385
IEC751
0.5 Hz
12 Bit
±0.8°C
±0.4°C
Bitlink load:
1.5
Order no:
DPBIT34-A1 (RJ12 connector)
DPBIT34-B1 (terminal block)
Page 1 of 2
BITLINK A/S | Marienlunds Alle 2 | DK-7430 Ikast | Denmark | Phone +45 97 15 58 03 | Fax +45 97 15 58 33 | Mail [email protected]
Data sheet | DPBIT34 | 1-channel PT100 sensor amplifier | 2-wire bus
Dimensions
16,5
mm
90,5 mm
58 mm
60,6 mm
Page 2 of 2
BITLINK A/S | Marienlunds Alle 2 | DK-7430 Ikast | Denmark | Phone +45 97 15 58 03 | Fax +45 97 15 58 33 | Mail [email protected]