Download Report

https://www.passcert.com/JN0-348.html
Pass Juniper JN0-348 Exam With Valid Dumps
Juniper JN0-348 Exam
Enterprise Routing and Switching, Specialist
https://www.passcert.com/JN0-348.html
Save 20% OFF, Including Juniper JN0-348 Exam Dumps
Pass JN0-348 Exam with Passcert Juniper JN0-348 dumps in
the first attempt.
https://www.passcert.com/
100% pass
https://www.passcert.com/JN0-348.html
1.What are two benefits of 802.3ad link aggregation?
A. It ensures symmetrical paths.
B. In increases bandwidth
C. It creates physical layer redundancy
D. It simplifies interface configuration.
Answer: BC
2.What is the purpose of the configuration shown in the exhibit?
A. This configuration causes all routes for directly connected interfaces to be installed in
oth the inet.0 routing table and the inet.0 routing table for the blue routing instance.
B. This configuration allows you to specify my-rib-group in a static route's next-table
statement to cause the static route to first try to resolve the address in inet.0 and then in
blue.inet.0.
C. This configuration causes all routes for directly connected interfaces that are assigned
to the blue routing instance to be installed in both the inet.0 routing table and the inet.0
routing table for the blue routing instance.
D. This configuration causes all routes from inet.0 to also be installed in blue.inet.0.
Answer: A
3.Which statement regarding the benefits of using GRE instead of IP-IP tunneling is true?
A. GRE supports authentication.
B. GRE supports private IP addresses over the Internet.
C. GRE supports encryption.
D. GRE supports both IP traffic and non-IP traffic.
Answer: D
4.Which two put ge-0/0/0 and ge-0/0/1 into the VLAN data?
A. set interfaces interface-range data-ports member ge-0/0/0
set interfaces interface-range data-ports member ge-0/0/1
set interfaces interface-range data-ports unit 0 family ethernet-switching vlan members
data
B. set interfaces ge-0/0/0 to ge-0/0/1 unit 0 family ethernet-switching vlan members data
C. set interfaces ge-0/0/0 unit 0 family ethernet-switching vlan members data
set interfaces ge-0/0/1 unit 0 family ethernet-switching vlan members data
100% pass
https://www.passcert.com/JN0-348.html
D. set interfaces ge-0/0/0-1 unit 0 family ethernet-switching vlan members data
Answer: AC
5.Which two statements are true about IS-IS router behavior?
A. If an IS-IS DIS attached to a broadcast, multi-access network fails, a new DIS is
elected.
B. An IS-IS router attached to a broadcast, multi-access network establishes an
adjacency only to the network's elected DIS.
C. An IS-IS router attached to a broadcast, multi-access network establishes adjacencies
with all of its neighbors on the network.
D. If an IS-IS DIS attached to a broadcast, multi-access network fails, the backup DIS
assumes the primary DIS role.
Answer: AC
6.You want several different subnets within your enterprise network to be reachable from
outside the enterprise network.
Your edge router must share a single route advertisement about these subnets with
external devices. If one of the subnets is unavailable, your edge router should drop any
traffic destined to that subnet.
Which type of route, configured on the edge device with default behavior, accomplishes
these objectives?
A. a primary contributing route
B. an OSPF route
C. an aggregate route
D. a generated route
Answer: C
7.You are currently defining a new OSPF area. The area must advertise external routes
but should not receive external routes from another area. In this scenario, which type of
area should you define?
A. stub
B. backbone
C. not-so-stubby
D. totally stubby
Answer: A
8.You configured an aggregate route of 192.168.8.0/21 and committed the updated
configuration. Using an operational show command, you notice that the newly configured
route is not present in the output.
What would explain this behavior?
A. There are no active contributing routes.
B. The next hop is not resolvable.
C. The next hop is not reachable.
D. An aggregate route will not show up in the local table; it will be shared only with BGP
100% pass
https://www.passcert.com/JN0-348.html
neighbors.
Answer: A
9.Referring to the exhibit, which type of route is displayed?
A. generate
B. aggregate
C. martian
D. static
Answer: B
10.A root bridge in an RSTP network is connected to other neighboring bridges using
point-to-point links.
Which combination of port types can exist on the root bridge?
A. There can be some combination of designated ports and alternate ports.
B. All ports will be designated ports.
C. All ports will be root ports.
D. There can be some combination of root ports and alternate ports.
Answer: B
100% pass
https://www.passcert.com/JN0-348.html
CCNP 300-101,300-115,300-135
CompTIA A+ 220-1001,220-1002
Storage C1000-016, C1000-020, C1000-021, C1000-022
Azure Architect AZ-300, AZ-301
Coating Inspector NACE-CIP1-001, NACE-CIP2-001
HCIP-R&S H12-322-ENU, H12-322-ENU, H12-322-ENU
HCIP-Storage H13-621-ENU, H13-622-ENU, H13-623-ENU
365 Certified: Enterprise Administrator Expert MS-100, MS-101
365 Certified: Teamwork Administrator Associate H12-322, H12-322
365 Certified: Modern Desktop Administrator Associate H12-322, H12-322
NSE 5 Network Security Analyst NSE5_FMG-6.0, NSE5_FAZ-6.0
Certified: Azure Data Engineer Associate H12-322, H12-322
MCSA: Windows Server 2016 H12-322,70-741,70-742
CCNA Data Center 200-150,200-155
CCNA Cyber Ops 210-250,210-255
HCIP-Security H12-721-ENU, H12-722-ENU, H12-723-ENU
HCIP-Cloud Computing H13-522-ENU, H13-523-ENU, H13-524-ENU
CCNP Data Center 300-160,300-165,300-170,300-175
CCNA 200-105,100-105
CCNP Security 300-206,300-208,300-209,300-210
CCNA Collaboration 210-060,210-065
TOGAF 9 Certified OG0-091, OG0-092
CompTIA A+ New 220-901,220-902
LX0-103, LX0-104
LPIC-1 101-400,102-400
LPIC-2 201-450,202-450
HCIP-WLAN H12-321-ENU, H12-322-ENU
100% pass