#1282 Deluxe Easel Assembly Instructions

#1282 Deluxe Easel
Assembly Instructions
IMPORTANT! This file contains the assembly instructions for three different versions of this item.
Please refer to the table below to determine which instructions match your item, and on which
pages you can find them.
Version A
pages 2-9
FEATURE
Version B
pages 10-23
Version C
pages 24-31
Chalkboard and dry-erase board frames need to be attached with screws and knobs
(versus permanently glued frames)
Upper and lower legs mate front to back with L-shaped notch
(versus side to side with no notch)
Paper roll spindle has smaller dowels on ends (versus screw holes on ends)
Side leg braces have a single notch (versus two notches)
Green dowel in side of upper legs for side braces
A B C
X X
X X
X
X
X X
Assembly Instructions
In order to construct the easel at the appropriate configuration for your child,
you must decide at which of the three height levels you wish to assemble the
(A) chalkboard and (D) dry-erase board (art boards). Use the table below as a
guideline:
Child’s height
Typical age range
Recommended art board
height
Less than 40 inches
(3 feet 4 inches)
3 and 4 years
Lowest
Between 40 and 48 inches
5 and 6 years
Middle
48 inches and up
7 and up
Highest
After choosing the appropriate art board height for your child, follow the
instructions that correspond to that height:
Highest height
Pages 3-6
Middle height
Pages 7-10
Lowest height
Pages 11-14
Note: When assembling the easel with the art boards at the lowest height, you
will use all the supplied hardware (bolts, washers and plastic knobs). When
assembling the easel with the art boards at the middle or highest height levels,
there will be unused hardware. This is perfectly normal.
Choose Melissa & Doug art supplies to use on
your new Deluxe Art Easel. The #4145 Easel
Accessory Set has everything your child needs to
get started!
Chalkboard preparation:
The chalkboard must be “seasoned” before use.
You will need to hold a piece of chalk horizontally
and rub the entire surface of the chalkboard,
covering it completely. Take a dry paper towel
and, using an overlapping circular motion, rub
the entire chalkboard surface. Finally, wipe the
chalkboard surface with a chalkboard eraser.
Your chalkboard is now seasoned and ready for
use.
Dry-erase board tips:
Make sure you use markers that are specifically
formulated for use on dry-erase board surfaces.
Do not use permanent markers or you will
damage the dry-erase surface. You can clean
the dry-erase board surface using a felt eraser or
a dry paper towel.
Page 2 of 14
! "
#
#
$
! "
#
$
( #
##
##
$
*
! "
! "$ )
)
% ,
'
'
#
$
#%
#
)
*
%
% & $
#%
$
$
! "
#
! "$ )
! "
*! "
# $)
#
% & $
! "
#
#
'
#
#% +#
!&"
! "
#
#
%
! "
% +#
'
!&"
Page 3 of 14
# $
$
! "
#%
# $
!
"$
% ( ! !'
!
! $
! "
,
! "
!
!
$
!
$
%
& !' $
!
%
$ +
!'
&
!
&#.
%
$
!
& !'
!
%
!
! !
!
!'
!
"
%
/
( !
! "
!
!
"$ )
!
"
* +
"$
!
!
" !
"
Page 4 of 14
!'
(
%
* +
#
!
!
% $
%
! " !
!
" !
!
&!"! !
% "
!
!
"
#
(
#
" $
" '
%&
" $
% "
) *
+
"
%&
%
#
#
" '
" ,
"
Page 5 of 14
(
%
$
%& '
(
(
(
)
*
(
(
$
(
(
+ ,
$
)
-& '
#
*
(
+ ,
!
(
$
(
(
(
!
#
! "
Page 6 of 14
#
"
!
"
!
)
"
!
"
"
" "
"# "
& # !#
#
% *#
"
, -"#
"
!" "
+
"
#
"
"
$
(
"
#
"
%
$!
/
#
&
!
"
$
$
"
#
% '
+
"
""
/
"$
# "
%
#
"$
!
. "
$ "
% '
%
!" "
!
# $ ("
"
"
"
!
!"
#
" !
"
$
(
# $ ("
"
# "
#
/
/
#
#!
"
#%
$
%
#
"
%
" % + $
"
"
" !#
!
!
$ (
&
$ "
"
# $ (" % + $
$ (
" # $!
$ $ "
# $ (" & # !#
%
Page 7 of 14
"
$
"
!
#
"!
$
"
"
(
"
"
! "
'
%
$ &
"
!
$
% $
"
"
)
'
"
$ &
$
#
$
#
!
$
Page 8 of 14
"
!
$
"
!
"
$
# *
!
$' - *# $
&
&$
&
# $
" # # $
"
!
/
$ # #$
#
'
+
'
0 +
&
&
' (
&$
#$
$
$
$
#
' )
& ' )
&
#
# $
$
#
+
% #
&$
#
.#
&$
#
&
# *
#
# *
" # # $
#
'
" #&"
" ' )
' ,
#
# &
$
#$
#
Page 9 of 14
# $
&
!
$
" & # $
$'
!
#
' (
" # # $
. " *# $ &
#$
#
"
+
'
#&"
$
%& '
(
(
(
)
*
(
+ ,
$
)
!
-& '
#
*
(
+ ,
(
$
(
$
(
(
!
#
! "
Page 10 of 14
!"
"
"
$
"
"
&
$
!
!
!
"
!
$
# %
'!
# (
#
'
# '
" $
$
# (
$
!
!
"
# %
$
&$
)
)
# +
&$
$
!
"
"
!
& $
# , &
"
$
$
'!
#
&$
# +
-
&$
"
"
"
&
Page 11 of 14
&$
$
./
!
&$
!#
!
"
$
"
*
!
"
$
$
#
!
"
!
"!
! "
(
"
%
"
!
# &
#
$
'
#
)
"
"
!
*
# &
#
% #
*
'
!
"
"
"
(
#
Page 12 of 14
!" #
!$ #
# %
)
#
'
#!
#
,
&
#%'
' & *
& -
'
%!
%
#
%!
#
%!
"
%
#
# %
%
#
,
' % # !
!&
%
(
!"
!& . +# !
%!
%
& )
' # # !
" ' +# ! %
& *
1
'
%
#%'
# +
#
&
'
%
#
1
&
Page 13 of 14
#
# +
&
%!
!
# !
!
' # # !
!
'
(
/
! # #!
#!
#
&
0 ,
,
# !
#
# +
#
!
"#
(
!
#!
#
#
1
$
%& '
(
(
(
)
*
(
(
$
(
+ ,
$
)
!
-& '
#
*
(
(
(
$
+ ,
(
!
#
! "
Page 14 of 14
ASSEMBLY INSTRUCTIONS
Before you begin assembly, make
sure that you have all the parts
listed below. Please use the (L)
Allen wrench for assembly.
Deluxe Standing Art Easel
2 upper
B hinged legs
C 4 lower legs
D
A
1 dry-erase board
1 chalkboard
E 1 paper guide/cutter
H 2 leg braces
F 1 upper art board frame with logo
G 2 lower art board frames
J 20 short screws
I
K
1 paper roll dowel
6 long screws
L 1 Allen wrench
M 26 plastic knobs
N
4 plastic clips
Please note that some hardware may be supplied with extra pieces.
O 1 blue plastic tray
P
1 red plastic tray
We care about your comments. Please call us!
ITEM #1282 Ver B 2007
1-800-284-3948
c
2007 Melissa & Doug, LLC P.O. Box 590, Westport, CT 06881
Deluxe Standing Art Easel
STEP
1
Assemble the upper legs(B) to the lower legs(C) as follows:
Use 8 Short Screws(J) and 8 colored knobs(M) for this step
to make the two identical leg assemblies as shown below.
Screws that face the
correct way will be
recessed as shown here.
No screw heads should
be above the surface
of the wood.
NOTE: The numbers
on the upper legs and
the lower legs should
face each other
for proper assembly.
Match the #1
on the upper leg
to the #1 on the
lower leg.
Do the same for
the #2 on the
upper and lower
legs.
Parts needed for this step:
2-Upper Leg Assemblies(B)
4-Lower Legs(C)
8-Short Screws(J)
8-Plastic Knobs(M)
Tighten all screws and knobs using
the supplied Allen Wrench (L)
2
Deluxe Standing Art Easel
STEP Assemble 2 Leg Braces(H) to the sides of the legs as shown below.
Use 4 Long Screws(K) and 4 colored Knobs(M) for this step.
2
Parts needed for this step:
2-Leg Braces(H)
4-Long Screws(K)
4-Plastic Knobs(M)
3
Deluxe Standing Art Easel
STEP
3
Using the Height Suggestions on the following page, assemble the
White Dry Erase board as follows:
With the Hinges facing each other, assemble the White Dry Erase
board to the two leg assemblies as shown below. Note that Long
Screws go at the top, and Short Screws at the bottom.
Paper Cutter(E)
Hinges face
each other
"TOP" facing up
You will need to open
the legs wider to get
these screws in place
if using the top holes.
Back View
2 Long Screws(K)
for the top
Frame(G)
2 Short Screws(J)
for the bottom
Parts needed for this step:
1-Dry Erase Board(A)
1-Paper Cutter(E)
1-Lower Frame(G)
2-Long Screws(K)
2-Short Screws(J)
4-Plastic Knobs(M)
Tighten all screws and knobs using
the supplied Allen Wrench (L)
4
Deluxe Standing Art Easel
HEIGHT SUGGESTIONS
Choose the 3rd hole
from the top
Height Position 1 Child's Height= Less than 40 inches
Typical Age = 3 to 4 years
Choose the 2nd hole
from the top
Height Position 2 Child's Height= Between 40 to 48 inches
Typical Age = 5 to 6 years
Choose the top hole
Height Position 3 Child's Height= From 48 inches and up
Typical Age = 7 years and up
5
Deluxe Standing Art Easel
STEP
4
Using 4 Short Screws(J) and 4 colored knobs(M), attach the
Green Chalkboard and frames as shown. Use the
suggested Heights from page 5 for the proper hole locations.
Remember, you will need to open the legs wider to get the
screws into the top position if using Height Position #3.
"TOP" facing Up
Frame(F) with the
Melissa and Doug Logo
Green Chalk Board
Frame(G)
Tighten all screws and knobs using
the supplied Allen Wrench (L)
Parts needed for this step:
1-Chalkboard(D)
1-Upper Frame(F)
1-Lower Frame(G)
4-Short Screws(J)
4-Plastic Knobs(M)
6
Deluxe Standing Art Easel
STEP
5
Attach the Paper Roll Dowel (I) to the side braces using
2 Short Screws (J) and 2 Colored Knobs(M) as shown below.
Attach the Blue Tray(O) and the Red Tray(P) as shown using
2 Short Screws(J) and 2 colored Knobs(M) for each Tray.
White Dry Erase
Board
Paper Dowel (I)
Blue
Tray
Red
Tray
Parts needed for this step:
Tighten all screws and knobs using
the supplied Allen Wrench (L)
1-Paper Dowel(I)
1-Blue Tray(O)
1-Red Tray(P)
6-Short Screws(J)
6-Plastic Knobs(M)
7
Deluxe Standing Art Easel
Plastic Clips(N)
Roll of Paper
(Purchased Separately)
The assembled Easel is shown here with a roll of paper held in
place with the 4 plastic clips on the White Dry Erase Board.
Choose Melissa and Doug art supplies to use with your new
Deluxe Art Easel. The #4145 Easel Accessory Set has everything
your child needs to get started.
Dry Erase Board Tips Make sure you use markers that are specially formulated for use on
dry erase surfaces. Do not use permanent markers or you will damage
the dry erase surface. Clean the board with a felt eraser or dry
paper towel.
8