1. No category

BUSHING WELL
LINDSEY #9592
LOADBREAK
“T” VOLTAGE
SENSOR
Lindsey # 9592 is a IEEE 386 type 200 Amp 15 kV
bushing load break “T” voltage sensor that provides a
1% accurate AC analog output voltage with an included
10 foot watertight connecting cable
Part Number
Lindsey # 9542/0111
Lindsey # 9542/0511
Output Voltage Device Impedance
0-5 Volts AC
1 Megohm
0-120 Volts AC 1 Megohm
LOADBREAK
BUSHING INSERT
LINDSEY #9532
LOADBREAK
ELBOW VOLTAGE
SENSOR
Lindsey # 9532 is a IEEE 386 type 200Amp 15 kV load
break Elbow voltage sensor that provides a 1% accurate
AC analog output voltage with an included 10 foot
watertight connecting cable
Part Number
Lindsey # 9532/0111
Lindsey # 9532/0511
Output Voltage Device Impedance
0-5 Volts AC
1 Megohm
0-120 Volts AC 1 Megohm
760 N.Georgia Avenue
Azusa, CA 91702 USA
Tel. 626-969-3471
www.lindsey-usa.com
Self contained 12 volt DC power source provides 5 ampere hours of continuous
energy in event of loss of input power for pad mount control/communication system
The Lindsey UG power supply (P/N 9251) uses a slip-core CT to generate DC energy to power
customer’s control/communication system, in the mean time, it also charges a built-in 12V 5AH
sealed Lead Acid battery. In the event of loss of input power, the self contained battery can provide
more than 10 hours of energy for the control/communication system. The CT harvests the power
from any phase of the 200A/600A underground cable system.Minimum of 30A line current is required
to run the power supply. The system has a water-resistant design to avoid moisture.
Features:
Specifications:
12Vdc for a typical microprocessor based
control/communication system
12V, 5AH telecom grade build-in battery with
temperature compensation
Applicable for 200A / 600A 15kV to 35kV
underground systems
Easy installation (split-core CT fits over the
underground cable and magnet-mount to the
inside wall of steel PAD mount enclosure), no
maintenance or calibration required
NEMA 4X fiberglass enclosure
Magnetic mounting
Utilizes passive Current Transformer for input power
Temperature compensated charging circuit to
prolong battery life
Floating ground design allows mounting flexibility
Long life internal sealed lead acid cell for low
maintenance
Wide operating temperature range
DC voltage output: up to 14V, 2.5A max
Build-in battery: 12V, 5 AH
Dimensions in inches:
With magnet mounts: 9 1/2” L x 7 5/8” W x 5” H
Without magnet mounts: 9 1/2 L x 7 5/8” W x 4 5/8” H
Operating temperature: -20F to 140F
Power supply/CT weight: 15 lbs
Shipping weight: 17 lbs.
US Patent #7633262 and other
Patents Pending
760 N.Georgia Avenue
Azusa, CA 91702 USA
Tel. 626-969-3471
www.lindsey-usa.com