1. No category

›
STEELEX
GROUP
high quality
aircraft heaters
High quality
aircraft heater
GENERAL DESCRIPTION
STEELEX E42, E75, D120
HIGH QUALITY
Steelex D120
all heaters constructed by Nordic heater are characterized by high quality.
Both chassi and frame are made from high quality stailess steel.
North-west from stockholm, in Kungsängen Nordic heater developes, designes and constructs both electric
and diesel-powered aircraft heaters of high quality.
e electric heaters are available in two models:
e 42 with a capacity of 42 kW and e75 with a capacity of 75 kW. for more details se pages 4 - 5.
e diesel heater is available in one model:
D120 with a capacity of 120 kW. for more details se pages 6 - 7.
steelex heater is a powerful aircraft heater which can cope with challenging climates. it is suitable for small aircraft,
cargo planes and jumbo jets. it is also used for heating lager places, in the armed forces and industry.
e heaters are sold around the world.
Contents:
General description
Page
New model & options
Steelex E42, E75
Steelex D120
Education
Contact information
2
3
4-5
6-7
8
8
2
NEW MODEL: DCP120
from autumn 2013 a D120 mounted on a small carco car is avaliable.
is arrangement gives direct accsess to move the heater, and there will be no waiting for a tow car.
Picture is showing a D120 heater mounted on a Peugeot Boxer 2013. The heater is also avaliable mounted on other cars.
OPTIONS
•
•
•
•
•
STEELEX DCP120, D120
Engine heater when appropriate.
Diesel- and battery heating.
Battery charger.
Oil and temperature monitoring
system.
Optional Kubota water cooled
diesel engine.
3
STEELEX E42, E75, DCP120, D120
• Heater hose longer than standard
7,5 meters.
• Beacon light. • Spare parts kit.
• GPS positioning system.
• Optional colors (taped, not spray
painted).
• Cable basket, for external electric
cable, mounted on the heater roof.
STEELEX E42, E75
T E C H N I C A L D ATA
e heater is equipped with drawbar and font wheel with parking brake activated by drawbar.
airblast fan and heater are powered by external electric power via 5 pins cee electric connector.
Power source
50 Hz, 3 phases 400 V, 63 Amp (model E42), 125 Amp (model E75)
Heating elements 42 kW (model E42), 75 kW (model E75).
Fan speed
Two fan speed level steps are selectable from the operators panel.
Fan speed 1 = 70% of available speed
Fan speed 2 = 100% of available speed.
Fan
Performance
Temperature
Direct driven by an electrical motor and speed
controlled by a frequency inverter.
The volume of air with hose connected to a Boeing 737-800 and
heater hose 7,5 meters and a diameter of 200 mm is 4000 m³/hour model E42
and 5000 m³/hour for model E75.
Two set-points available from the panel. Maximum is 60ºC
and the lower is 30ºC.
DIMENSIONS SPECIFICATION
STEELEX E42, E75
Lengh
Width
Height
Weight
1800 mm
1122 mm
1070 mm
330 kg
4
STEELEX E42, E75
EXTERNAL VIEWS
Drawbar lifts up for parking and braking of front steered wheel when unit is parked.
Operators panel in the rear chassis panel, covered with thick top suspended plastic for protection.
Operators panel give easy control of heater operation.
New and very efficient heater fan reduces power consumption and gives less noise from air duct.
heater hose is stored inside the heater chassis.
heater hose is stored inside the heater chassis.
M O R E D E TA I L S
• ree wheeled trailer with 13 inch puncture-resistance wheels.
• chassis and frame, as well as the hatches, are made from stainless steel.
• New and very energy effective heater fan.
• clean and very open and service friendly access to all components.
• 7,5 m long 200 mm diameter, heater air hose with very resistant PP connection to
aircraft as standard.
5
STEELEX D120
T E C H N I C A L D ATA
e heater is equipped with drawbar and front wheels, with parking brake activated by drawbar.
airblast fan and heater fan powered either by electric power from onboard diesel generator or from
external el.power via cee 16 amp connector mounted on outside rear heater chassis panel.
Onboard motor
Deutz
Air cold 2011. 2 cylinders.
Power source Generator
MeccAlte ECO3, 1500 rpm, 50Hz, 3 phases 400 V.
Fan
Direct driven by an electrical motor and speed controlled
by a frequency inverter.
Burner
Fan speed
Air volume: 5000 m³/h. assuming the hose, 7,5 meter long
and a diameter of 200 mm, is connected to the aircraft.
Temperature
DIMENSIONS
SPECIFICATION
STEELEX D120
Width
Height
Weight
120 kW.
Two speeds are selectable from the panel, 70% and 100%.
Performance
Lengh
Bentone
Two set-points available from the panel. Maximum is 60ºC
and the lower is 30ºC.
2500 mm
1350 mm
1600 mm
930 kg
6
STEELEX D120
EXTERNAL VIEWS
Drawbar lifts up for parking and locking of front steered wheels when unit is parked.
right hand side fitted operators panel, covered with thick top suspended plastic sheet for protection.
Operators panel gives easy control of diesel engine and heater operation.
air intake for fan and burner on right hand side of heater chassis body.
Diesel engine, heater chamber, generator and burner are easily accessed through top hinged service
access panel.
M O R E D E TA I L S
• 13 inch wheels on stiff rear axle. front axle steering with narrow mounted wheels.
• hatches are supported by gas cylinders.
• steel rims with cargo Max tires.
• chassis, frame, roof and hatches, are all made from stainless steel.
• New and very energy effective heater fan, which saves fuel.
• clean and very open and service friendly access to all components.
• 7,5 m long 200 mm diameter, heater air hose with very resistant PP connection to aircraft as standard.
• New burner 120 kW is fuel saving.
• 400 V 50 hz cee 16 amp connector fitted outside rear panel for alternative power.
• clean and easy engine oil drain via hose with quick fix connector,
(visible to the right side on engine mounting plate).
• heat exchanger is made from stainless steel.
7
• 1000 hours service intervals.
EDUCATION
When bying any heater from NORDIC HEATER, the price includes free training for your mechanic staff.
e training consists of one day education in maintaining and operating the heater.
education is held in Kungsängen, just 25 km north-west of stockholm, in the factory adjacent to the
headquarters of STEELEX GROUP. training is offered in swedish or english.
Brunna
Industriområde
STOCKHOLMS
VATTENSKÄRNING AB
Fr Enköping
COOP
FORUM
Kungsängen is easily reached by car,
via E18 in 25 min from Stockholm or from
Arlanda airport by car, approx. 30 min.
Take
exit 150, “Brunna”
Tag
avfart:
Kungsängen, Brunna
E18
GPS coordinates:
Lat: N 59° 30ʼ 31,34”
Long: E 17° 44ʼ 46,95”
Turn-off: Kungsängen
Avfart:
Kungsängen
Tibble
Fr Sthlm
Enköpingsvägen
NORDIC HEATER AB
Kraftvägen 24
S-196 37 Kungsängen
Sweden
Phone +46 8 584 700 21
Fax
+46 8 583 525 45
E-mail [email protected]
Nordic Heater AB is a part of Steelex Group
Your complete subcontractor concerning the metal manufacture industry