READ ALL INSTRUCTIONS BEFORE ASSEMBLY AND USE OF PRODUCT. KEEP INSTRUCTIONS FOR FUTURE USE. ADULT ASSEMBLY REQUIRED DUE TO THE PRESENCE OF SMALL PARTS DURING ASSEMBLY. Customer Service: Web Site: www.deltachildrensproducts.com Delta Children’s Products 114 West 26th Street New York, NY 10001 Tele.212-645-9033 Conforms to ASTM F406 Safety Standards THIS PRODUCT IS NOT INTENDED FOR INSTITUTIONAL OR COMMERCIAL USE. MAKE SURE THAT ALL PRE-ASSEMBLED PARTS ARE TIGHT. THE APPEARANCE OF YOUR PRODUCT MAY BE DIFFERENT FROM THAT PICTURED IN THIS BOOK. If you have any questions or missing parts, contact us. DO NOT return product parts to the store from where it was purchased before contacting Delta Children’s Products Customer Service. To register your product for important safety alerts and updates to your product please visit http://deltaenterprise.com/register.asp NOVEMBER 23, 2009 4490-R6 ©2009 DELTA ENTERPRISE CORP. CAUTION: ANY MATTRESS USED IN THIS CRIB MUST BE AT LEAST 36 1/2 INCHES LONG BY 22 INCHES WIDE AND NOT MORE THAN 2 INCHES THICK. WARNING: INFANTS CAN SUFFOCATE * IN GAPS BETWEEN A MATTRESS TOO SMALL OR TOO THICK AND PRODUCT SIDES. *ON SOFT BEDDING. NEVER ADD A MATTRESS, PILLOW, COMFORTER OR PADDING. USE ONLY THE MATTRESS PROVIDED BY DELTA CHILDREN’S PRODUCTS. (WHICH MUST BE AT LEAST 36 1/2 INCHES LONG BY 22 INCHES WIDE AND NOT MORE THAN 2 INCHES THICK.) WARNING FAILURE TO FOLLOW THESE WARNINGS AND THE ASSEMBLY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. TO REDUCE THE RISK OF SIDS, PEDIATRICIANS RECOMMEND HEALTHY INFANTS BE PLACED ON THEIR BACKS TO SLEEP, UNLESS OTHERWISE ADVISED BY YOUR PHYSICIAN. *STRINGS CAN CAUSE STRANGULATION! NEVER PLACE ITEMS WITH A STRING AROUND A CHILD'S NECK, SUCH AS HOOD STRINGS OR PACIFIER CORDS. NEVER SUSPEND STRINGS OVER PRODUCT OR ATTACH STRINGS TO TOYS. *THE PRODUCT, INCLUDING SIDE RAILS, MUST BE FULLY ERECTED PRIOR TO USE. *NEVER PLACE PRODUCT NEAR A WINDOW WHERE CORDS FROM BLINDS OR DRAPES CAN STRANGLE A CHILD. * WHEN CHILD IS ABLE TO PULL TO A STANDING POSITION, SET MATTRESS TO LOWEST ADJUSTMENT POSITION AND REMOVE BUMPER PADS, LARGE TOYS AND OTHER OBJECTS THAT COULD SERVE AS STEPS FOR CLIMBING OUT. *DISCONTINUE USE OF THE PRODUCT WHEN CHILD IS ABLE TO CLIMB OUT OR REACHES THE HEIGHT OF 35 IN. (890 mm). *NEVER USE THIS PRODUCT IF THERE ARE ANY LOOSE OR MISSING FASTENERS, LOOSE JOINTS OR BROKEN PARTS. CHECK BEFORE ASSEMBLY AND FREQUENTLY DURING USE. CONTACT DELTA CHILDREN’S PRODUCTS FOR REPLACEMENT PARTS. NEVER SUBSTITUTE PARTS. *NEVER USE A WATER MATTRESS WITH THIS CRIB. *IF REFINISHING, USE A NON-TOXIC FINISH SPECIFIED FOR CHILDREN'S PRODUCTS. *NEVER USE PLASTIC SHIPPING BAGS OR OTHER PLASTIC FILM AS MATTRESS COVERS NOT SOLD AND INTENDED FOR THAT PURPOSE. THEY CAN CAUSE SUFFOCATION. *ENSURE A SAFE ENVIRONMENT FOR THE CHILD BY CHECKING REGULARLY, BEFORE PLACING THE CHILD IN THE PRODUCT, THAT EVERY COMPONENT IS PROPERLY AND SECURELY IN PLACE. *TO AVOID HEAD INJURY, DO NOT ALLOW ANY CHILD TO PLAY UNDERNEATH THE PRODUCT. *ALWAYS PROVIDE THE SUPERVISION NECESSARY FOR THE CONTINUED SAFETY OF YOUR CHILD. WHEN USED FOR PLAYING NEVER LEAVE CHILD UNATTENDED. 2 PARTS B. BACK RAIL TOP C. REAR LEG LEFT A. BACK RAIL BOTTOM D. REAR LEG RIGHT H. FRONT RAIL TOP G. FRONT RAIL BOTTOM E. FRONT LEG LEFT F. FRONT LEG RIGHT J. MATTRESS SUPPORT POUCH ATTACHED TO MATTRESS SUPPORT - KEEP INSTRUCTIONS AND ANY EXTRA HARDWARE AND TOOLS IN THIS POUCH AFTER ASSEMBLY WARNINGS RELATED TO THE SAFE USE OF THIS CRIB ARE PRINTED ON THE POUCH P.CRIB ENDS x2 3 PARTS - HARDWARE AND TOOLS K.50mm BOLT x 4 L.32mm BOLT x 16 M. 17mm BOLT x 8 N. DOWEL x2 ALL HARDWARE ON THIS PAGE IS SHOWN FULL SIZE AND WITH THE CORRECT DESIGN.THE PARTS CAN BE MATCHED TO THE PICTURES. R. FOAM PAD M4 ALLEN WRENCH SUPPLIED 4 SECTION 1: CRIB ASSEMBLY STEP 1 PARTS AND TOOLS REQUIRED TO COMPLETE STEP L. 32mm BOLT x 4 A. BACK RAIL BOTTOM C. REAR LEG LEFT M4 ALLEN WRENCH SUPPLIED D. REAR LEG RIGHT ATTACH THE BACK RAIL BOTTOM (PART A) TO THE REAR LEG LEFT (PART C) AND THE REAR LEG RIGHT (PART D) WITH (4) M6x32mm BOLTS (PART L) USING THE M4 ALLEN WRENCH AS SHOWN. L A NOTE : THE SLOT IN PART A MUST FACE UP. D L L C L 5 SECTION 1: CRIB ASSEMBLY STEP 2 PARTS AND TOOLS REQUIRED TO COMPLETE STEP L. 32mm BOLT x 2 B. BACK RAIL TOP M4 ALLEN WRENCH SUPPLIED FROM STEP 1 INSERT THE TENON OF THE BACK RAIL TOP (PART B) INTO THE SLOT ON TOP OF THE BACK RAIL BOTTOM (PART A), THEN INSERT THE M6x32 mm BOLTS (PART L), THROUGH THE REAR LEGS INTO THE THREADED INSETS ONTO THE BACK RAIL TOP (PART B) AS SHOWN. L B L A 6 SECTION 1: CRIB ASSEMBLY STEP 3 PARTS AND TOOLS REQUIRED TO COMPLETE STEP L.32mm BOLT x 4 E. FRONT LEG LEFT F. FRONT LEG RIGHT M4 ALLEN WRENCH SUPPLIED P.CRIB ENDS x2 ATTACH THE FRONT LEG LEFT (PART E) AND FRONT LEG RIGHT (PART F) TO THE CRIB ENDS (PART P) WITH (4) M6x32 mm BOLTS (PART L) USING THE M4 ALLEN WRENCH AS SHOWN. L L P P L L F E 7 SECTION 1: CRIB ASSEMBLY STEP 4 PARTS AND TOOLS REQUIRED TO COMPLETE STEP K.50mm BOLT x 4 FROM STEP 3 FROM STEP 2 N. DOWEL x2 M4 ALLEN WRENCH SUPPLIED ATTACH THE ASSEMBLY FROM STEP 2 TO THE ASSEMB LIES FROM STEP 3 WITH (4) M6x50 mm BOLTS (PART K) AND (2) DOWELS (PART N) USING THE M4 ALLEN WRENCH AS SHOWN. K N K K N K 8 SECTION 1: CRIB ASSEMBLY STEP 5 PARTS AND TOOLS REQUIRED TO COMPLETE STEP M. 17mm BOLT x 4 FROM STEP 4 J. MATTRESS SUPPORT M4 ALLEN WRENCH SUPPLIED ATTACH THE MATTRESS SUPPORT (PART J) TO THE ASSEMBLY FROM STEP 4 WITH (4) 17mm BOLTS (PART M) USING THE M4 ALLEN WRENCH SUPPLIED. THERE ARE (3) POSITIONS FOR THE MATTRESS SUPPORT.USE THE HIGHEST ONLY FOR NEW BORNS.MOVE THE MATTRESS DOWN AS THE CHILD GROWS. M ALL CORNERS M M M J M THIS SIDE UP. J ! WARNINGS ON POUCH MUST FACE UP. 9 SECTION 1: CRIB ASSEMBLY STEP 6 PARTS AND TOOLS REQUIRED TO COMPLETE STEP L.32mm BOLT x 4 G. FRONT RAIL BOTTOM FROM STEP 5 M4 ALLEN WRENCH SUPPLIED ATTACH THE FRONT RAIL BOTTOM (PART G) TO THE ASSEMBLY FROM STEP 5 WITH (4) M6x32 mm BOLTS (PART L) USING THE M4 ALLEN WRENCH AS SHOWN. NOTE : THE SLOT IN PART G MUST FACE UP. L L L G L 10 SECTION 1: CRIB ASSEMBLY STEP 7 PARTS AND TOOLS REQUIRED TO COMPLETE STEP L.32mm BOLT x 2 H. FRONT RAIL TOP M4 ALLEN WRENCH SUPPLIED FROM STEP 6 INSERT THE TENON OF THE FRONT RAIL TOP (PART H) INTO THE SLOT ON TOP OF THE FRONT RAIL BOTTOM (PART G) OF THE ASSEMBLY FROM STEP 6 , THEN INSERT THE M6x32 mm BOLTS (PART L),THROUGH THE RRONT LEGS INTO THE THREADED INSETS ONTO THE FRONT RAIL TOP (PART H) AS SHOWN. H L L 11 SECTION 1: CRIB ASSEMBLY STEP 8 PARTS AND TOOLS REQUIRED TO COMPLETE STEP FROM STEP 7 R. FOAM PAD PLACE THE FOAM PAD (PART R) ONTO THE MATTRESS SUPPORT (PART J) AS SHOWN. P 12 SECTION 2: TWIN BED CONVERSION PARTS AND TOOLS REQUIRED TO COMPLETE STEP M. 17mm BOLT x 4 M4 ALLEN WRENCH SUPPLIED THIS CRIB CAN BE CONVERTED INTO A TWIN BED HEADBOARD. THE ASSEMBLY FROM STEP 2 IS THE HEADBOARD FOR THE TWIN BED. REMOVE ALL PARTS INSTALLED AFTER STEP 2,IN REVERSE ORDER,AND STORE THEM SAFELY. STAND HEADBOARD UP. USE THE 17MM BOLTS(PART M) TO ATTACH THE HEADBOARD TO THE BED FRAME, CONTACT DELTA CHILDREN’S PRODUCTS WITH QUESTIONS. NOTE: BED FRAMES ARE NOT SUPPLIED WITH THIS SYSTEM, BUT CAN BE PURCHASED AT MATTRESS STORES. 13 Customer Service: Web Site: www.deltachildrensproducts.com Delta Children’s Products 114 West 26th Street New York, NY 10001 Tele.212-645-9033 Warranty: This Delta Crib is warranted to be free from defects for a period of 1 year from the date of purchase under normal use. This warranty extends only to the original retail purchaser and is valid only when supplied with proof of purchase, or if received as a gift, when the registration is on file with Delta. To register your product for important safety alerts and updates to your product please visit http://deltaenterprise.com/register.asp Please do not return this item to the store before contacting us about missing parts or with any questions. In the event that you need to contact our customer service department please have the Style Number and Lot Number available. To report a problem, please log on to www.deltachildrensproducts.com and click the Customer Service Tab, or log on to www.deltaenterprise.com/customer_service.asp, or contact us by phone at (212) 645-9033. Use the space below to make note of those numbers. They can be found on the label on Crib End bottom rail. Style No.:______________________ Lot No. : _______________________ Pack Date:_____________________ Date of Purchase: _____________ (you should also keep your receipt)