Download Report

JS250DF
Shave Raised Edge To Clear
GE® 30" Slide-In Electric Range
30" Min.
Recommended
6" Min.
From Walls
(Attaches to the back of range
as a backguard when unit is
9/16
installed in 30" free-standing
cutout)
JXS32SS (Stainless) - 4" High
30" JXS32BB
Min.
(Black) - 4" High
Acceptable
Optional
Lower Trim Kits
Electrical
Outlet
(If counter Area
height is greater
-3/16
Acceptable
Electrical
Outlet Area
23-3/16
35-7/8"–38"
from floor to
countertop
Body Sides
(Slide-in ranges are sold
without sides installed. CanIf you are NOT using the
be installed on either left Filler strip or Backguard:
or right when unit has one
exposed side [no cabinet
adjacent]. Kit contains
1 body side)
23-3/16
JXS77BB (Black)
31-1/8" Wide Control Panel
30" Min.
30" Min.
15" Min.
Rear Filler Strip
WB07T10680 - Black Filler Strip Assembly
2-1/2
7-1/2
35-7/8"–38"
from floor to
countertop
7-1/2
30
30
If you are NOT using the
Filler strip or Backguard:
24
If you are using the
Filler strip or Backguard:
KW Rating
2-1/2
240V
11.9
208V
8.9
31-1/4
30
4
24
240V 40 Amps† 2-1/2
20-5/8" Door
Clearance
From Front
Surface of
Countertop
25-3/4*
30
30
208V 40 Amps†
(excluding handle)
15" Min.
†
Note: Check local codes for required breaker size.
2-7/8"
To Front
urface Of
1/2
24
31-1/4
30
25
*Total depth from wall to
front of closed oven door
including handle is 28-1/2.
25-3/4*
If you are using the Accessory
Backguard JXS32
Filler strip or Backguard: For answers to your Monogram® or GE®
25
30
36-1/4
20-5/8" Door
Clearance
From Front
Surface of
Countertop
Breaker Size
30
31-1/4
2-7/8"
To Front
Surface Of
Countertop
25
23-3/16
7-1/2
2-1/2
Accessory
Backguard JXS32
2-7/8"
To Front
Surface Of
Countertop
30
25
2-1/2
2-1/2
30
15" Min.
If you are using the
Filler strip or Backguard: 25
15" Min.
than 36.5", a lower trim kit
is recommended to extend
Edge To Clear the useful height to 38"
25
Control Panel maximum)
odel JSS28
JXS56BB – Black
Acceptable
30
Electrical
Outlet Area
23-3/16
25
Installation Information: Before installing, consult installation insgtructions
for current dimensional data and additional requirements
30" Min
Accessory
Backguards
Excluding
Model JSS28
.
9/16
23-3/16
Receptacle Locations: Locally approved flexible service cord or conduit must
be used because terminals are not accessible after range installation. See
shaded area in drawing for location of electrical outlet box. Recommended
outlet locations allow range to be installed directly against rear wall.
Optional Kits For Slide-In
Electric Ranges
(Available Shave
At Additional
Raised EdgeCost)
To Clear
6" Min.
From Walls
9/16
Dimensions and Installation Information (in inches)
Note: This appliance has been approved for 0” spacing to adjacent
surfaces above the cooktop. However, a 6” minimum spacing to surfaces
less than 15” above the cooktop and adjacent cabinet is recommended
to reduce exposure to steam, grease splatter and heat.
31-1/8"
Wide
If you are NOT
using
theControl Panel
30" Min.
Excluding Model JSS28
Filler strip or Backguard:
Shave Raised Edge To Clear
31-1/8" Wide Control PanelRecommended
Excluding Model JSS28
*
ADA qualified based
on Uniform Federal
Accessibility Standards
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
If the countertop area is not flat, excess tension may be applied to the glass cooktop, causing breakage and
voiding the warranty. Make sure the wall covering, countertop, flooring and cabinets around the range can
withstand
® the heat (up to 200°F) generated by the range.
appliance questions, visit our website at
geappliances.com or call GE Answer Center
A. Allow 30" minimum clearance between surface units and bottom of unprotected wood or metal cabinet, or
allow a 24" minimum when bottom of wood or metal cabinet is protected bySpecification
no less than 1/4"-thick
service,
800.626.2000.
4
Created 6/13
flame-retardant millboard covered with no less than No. 28 MSG sheet metal (.015" thick), .015"-thick stainless
steel, .025" aluminum or .020" copper.
(excluding handle
Listed by
Underwriters
Laboratories
320636
If the countertop area is not flat, excess tension may be applied to the glass c
voiding the warranty. Make sure the wall covering, countertop, flooring and
B. This appliance has been approved for 0" spacing to adjacent surfaces above the cooktop.
However, a minimum 6" spacing to surfaces less than 15" above the cooktop and adjacent
cabinetry
withstand
the heat (up to 200°F) generated by the range.
is recommended to reduce exposure to steam, grease splatter and heat. Allow 1/4" minimum
JS250DF
GE® 30" Slide-In Electric Range
Features and Benefits
• Self-Clean Oven - Cleans the oven cavity without the need for scrubbing
•Coil Heating Elements - Provide even heat and easy cleanup
•4.4 cu. ft. Oven Capacity - Enough room to cook an entire meal at once
•Removable Full-Width Storage Drawer - Store cookware or kitchen
accessories
LIGHT
•Dual Element Bake - Upper and lower elements produce even heat and
great results
•Electronic Oven Controls - Electronic touch pads are easy to operate
•Chrome Drip Bowls - Contain spills and remove for easy cleaning
• Model JS250DFWW - White on white
• Model JS250DFCC - Bisque on bisque
• Model JS250DFBB - Black on black
JS250DF
Specification Created 6/13
320636