1. No category

Exam
Name___________________________________
MULTIPLE CHOICE. Choose the one alternative that best completes the statement or answers the question.
1) Two technicians are discussing the heater output temperature. Technician A says that a valve is
used to reduce coolant flow through the core when less heat is desired. Technician B says that most
modern systems use a blend-air door to control the coolant flow. Which technician is correct?
A) Technician A only
B) Technician B only
C) Both technicians
D) Neither technician
1)
2) A hybrid vehicle may use which of the following to warm the vehicle occupants?
A) A heat pump
B) PTC heater elements
C) An auxillary water pump
D) Any of these
2)
3) A vehicle's heater is stuck in defrost only mode. This could indicate a failure of ________.
A) the heater system controls
B) the AC compressor
C) the thermostat
D) None of these
3)
4) Identify the heater core in this illustration.
4)
A) A
B) B
C) F
5) An aftermarket heater system consists of ________.
A) control switches
C) a core
D) D
B) a blower
D) All of the above
5)
6) Two technicians are discussing the coolant flow through a heater core. Technician A says that
heated coolant enters the heater inlet hose close to the engine thermostat. Technician B says the
coolant from the heater core returns to the water pump outlet. Which technician is correct?
A) Technician A only
B) Technician B only
C) Both technicians
D) Neither technician
6)
7) Coolant flow to the heater core may be controlled by a ________.
A) cable mechanism
B) vacuum mechanism
C) heater water control valve
D) Any of these
7)
1
8) Heater hoses are attached to the core using ________.
A) clamps
B) quick-connect couplings
C) Both A and B
D) Neither A nor B
8)
9) Some cars use metal tubing for coolant flow to the core to allow routing ________.
A) through very congested areas with tight bends
B) past very hot places
C) Either of these
D) Neither of these
9)
10) Two technicians are discussing heater hoses. Technician A says that most hoses have an inside
diameter of about one inch or larger. Technician B says the heater core inlet hose is usually larger
than the outlet. Which technician is correct?
A) Technician A only
B) Technician B only
C) Both technicians
D) Neither technician
2
10)