Page 1! Page !2 Contents Linear Features Page 03 Controller Layout Page 04 Using Linear Page 05 Useful Information Page 05 Support Page 05 Page !3 Linear Features 1 2 3 4 14 13 5 12 11 10 6 8 7 9 1. Pulley Belt 2. Motor 3. Carry Handle 4. Safety Clip Hole 5. Battery Location (Use Velcro Straps) 6. Electronics Box 7. Cooling Fan 8. Gimbal Plate 9. Cradle Fasteners (Wingnuts) 10. Cradle Arm 11. On/Off Switch + Battery Connection 12. Adjustable Third Wheel 13. Extra Camera Mount Hole 14. Drive Pulley Wheel Page !4 Linear Features 1 1. Deans (Battery) Connection 2. On/Off Switch 2 Controller Layout 1. Antenna 2. Gear/Engine Cut Switch 3. Plastic Side Panel 4. Rotation Stick 5. Power Switch 6. Throttle Stick 7. Power/Low Battery Indicator 8. Trim Switch 1 8 2 7 6 5 4 3 Page !5 Using Linear Turning On/Off To power on FIRST securely attach Shot-Lines Battery and connect it to the terminal on the side of the box (1) THEN turn on the controller (Make sure throttle stick is in centre position). At this point you can turn on the unit (2). If on the units cooling fan should initiate you will then here two ‘beeps’. At this point the unit should be ready to use. To Power off FIRST turn off the unit (2), then turn off the controller. If off the units cooling fan should be off. Disconnect the battery from the terminal (1) at this point the unit is safe to disassemble. We do not recommend that you remove or attach any cradle, camera or device while the unit is on. AS A PRECAUTION ALWAYS KEEP CONTROLLER ON WHILE UNIT IS ON AND/OR HAS BATTERY CONNECTED. Useful Information/Support Support www.shot-line.com/contact