Starbella Arctic Scarf By Premier Yarns Design Team Level: Beginner

Starbella Arctic Scarf
®
By Premier Yarns Design Team
Level: Beginner
SIZES
One Ball Scarf (Two Ball Scarf)
One Ball Scarf shown
FINISHED MEASUREMENTS
Length: 44 (88)”
Width: 4”
MATERIALS
Premier Yarns® Starbella® Arctic (100% acrylic;
100gm/7½ yds)
• #18-02 White Sand – 1 (2) balls
Needle: US Size 8 (5 mm) needles or size needed to
obtain gauge
Notions: Tapestry needle, or sewing needle and
thread
GAUGE
Gauge is not important in this project. Work evenly
and consistently throughout.
Directions:
STITCH GUIDE
To work with Starbella® Arctic
Pull out a short length of Starbella® Arctic and pull the ribbon widthways to open it up. The thick fur border
should be at the bottom for this project. The open loops will be referred to as the top of the yarn, and
these loops are what you will use to knit.
SCARF
Cast on 2 stitches as follows: Pull out a length of yarn and open it up; insert right needle into each loop
along top edge, working from back to front, turn.
Row 1: Knit 2, turn.
Repeat Row 1 until 10” of yarn remains. Bind off all stitches, pull yarn through last loop.
FINISHING
Weave in ends. You may prefer to use an optional sewing needle and thread to secure ends; trim close to
stitching.
©Premier Yarns 2013, All Rights Reserved
www.premieryarns.com