1. No category

Page
1 of 2
SUBMITTAL AM096FXVAFH/AA
Samsung DVM S Series, Heat Pump Condensing Unit
Job Name
Purchaser
Submitted to
Unit Designation
Location
Engineer
Reference
Schedule #
Approval
Construction
System Specifications
US Ton (nominal)
Capacity (Btu/h)
8
Nominal / Rated Cooling¹
96,000 / 92,000
Nominal / Rated Heating²
System Modulation Down to (Btu/h)
Performance
EER
Ducted / Non-Ducted
IEER
Ducted / Non-Ducted
108,000 / 103,000
7,513
11.6 / 15.0
23.0 / 38.2
Voltage
(ø/V/Hz)
Maximum Circuit Breaker (MCCB/ELB/ELCB)
Power
3 / 208-230 / 60
50
Minimum Circuit Ampacity (MCA)
N$
SCCR
5
Total Capacity (%)
Indoor Units
37.8
50 - 130% Of Outdoor Unit Capacity
Maximum Indoor Unit Quantity
16
Type
Compressor
SSC Scroll X 2
RLA (A)
12.5
Refrigerant
R410A Factory Charge (lbs.)
16.31
Pipe Connections
Liquid X Suction (inches)
3/8 X 7/8
Max. Distance - ODU to IDU (feet)
Installation
Limitation³
Vertical
Separation (feet)
ODU to IDU
656 (722 equivalent)
361 (ODU above) / 131 (ODU below)
Highest/Lowest IDU
Total Refrigerant Pipe (feet)
Fan
164
3,280
Propeller X 2
Type
Motor
DC
620 X 2
Output (W)
3.0
FLA (A)
Max. External Static Pressure ("WC)
0.31
51 X 66 3/4 X 30 1/8
WXHXD
Inches
Weight
lbs.
Sound Level
dB (A)
Max.
Operating
Temperatures
Cooling
°F
23 - 120
Heating
°F
-13 - 75
Dimensions
623.9
61
Safety Certifications
Heat Exchanger
The heat exchanger shall be mechanically bonded fin to copper tube.
Controls
The unit shall be operated via NASA Protocol with controls provided by Samsung
The outdoor unit shall have a removable EEPROM that stores unit serial number, startup
information, system settings, and system tag/name.
Controls shall integrate with a BMS system without additional interface modules
Control wiring shall be 16 AWG X 2 shielded wire.
Refrigerant System
The compressors shall be Samsung hermetically sealed, inverter driven, direct vapor
injected, DC scroll type with soft-start capability.
ETL & ETLc
Intelligent logic to ensure proper operation within unit design limitations and
operational parameters
High pressure sensor, low pressure sensor, over-voltage protection, compressor overcurrent protection, current transformer, fan motor voltage protection, fan motor thermal
Protection Devices
protection, overheat protection, phase detection protection, high voltage fuses
Inverter PCB cooling done with liquid refrigerant to maintain optimal and safe operating
temperatures
Accessories
Qty.
Construction
The unit shall be galvanized steel with a baked on powder coated finish.
9,182
Output (CFM)
Type
Condenser Fan
Compatibility
Only compatible with Samsung DVM S indoor units (AM****N*DCH***)
Description
Model Number
WHG-SL
Left wind/hail guard (1)
WHG-SR
Right wind/hail guard (1)
WHG-R
5HDUZLQGKDLOJXDUGIRUWRQRXWGRRUXQLW
WHG-T
7RSZLQGKDLOJXDUGIRUWRQRXWGRRUXQLW
MCM-C200
Vapor injected compressors provide improved performance in cooling and heating modes.
Refrigerant flow shall be controlled by EEV (electronic expansion valve) throughout the
system.
Subcooling devices in system maintain capacity at extreme system refrigerant pipe lengths
and minimize refrigerant noise.
Other Features
Asymmetrical scroll design with rotating compressor operation/priority (where applicable).
Optional night quiet modes to reduce outdoor unit sound (4 levels)
Optional snow blowing logic to prevent snow accumulation on idle outdoor units
Continuous operation while outdoor unit(s) change between heating and cooling modes
(conditions apply).
Mode selector switch for heat pump systems
¹ Nominal cooling capacities are based on: Indoor temperature: 80ͼF DB, 67ͼF WB. Outdoor temperature: 95ͼF
DB, 75ͼF WB.
² Nominal heating capacities are based on: Indoor temperature: 70ͼF DB, 60ͼF WB. Outdoor temperature: 47ͼF
DB, 43ͼF WB.
³ Other pipe restrictions and requirements exist. 3OHDVHFRQVXOWWHFKQLFDOGDWDERRNRULQVWDOODWLRQPDQXDOVIRU
IXOOGHWDLOVUHJDUGLQJOLPLWDWLRQVDQGRWKHUUHTXLUHPHQWVIRUYHUWLFDOVHSHUDWLRQRYHUIHHWRXWGRRUWRORZHVW
LQGRRU
Maximum current control of outdoor unit(s) to limit current (50% - 100% of design current)
adjustable at outdoor unit or central control devices: DMS 2 (MIM-D00AN), BACnet Gateway
(MIM-B17N), LON Gateway (MIM-B18N).
Energy savings options to reduce system energy consumption in heating mode when
average indoor room temperatures are greater than average indoor set temperatures.
Samsung and Quietside maintains a policy of ongoing development, specifications are subject to change without notice.
QS-DVMS-062015A
www.SamsungDVM-S.com
Page 2 of 2
SUBMITTAL AM096FXVAFH/AA
Samsung DVM S Series, Heat Pump Condensing Unit
AM096FXVAFH/AA Dimensional Drawing
66 3/4"
1 7/16"
30 1/8"
51"
4 1/4"
19 3/8"
6 3/4"
21 15/16"
2"
9 1/2"
4 13/16"
26 13/32"
24 1/4"
LEFT SIDE
RIGHT SIDE
7 15/16"
45 1/4"
22 5/8"
31 5/8"
29 31/32"
51"
BOTTOM
1 Gas refrigerant pipe opening
5 Power conduit opening (4 X Ø1 3/4")
2 Liquid refrigerant pipe opening
6 Communication conduit opening (8 X Ø7/8")
3 Power conduit opening (2 X Ø1 3/4")
7 Knock-out opening for refrigerant piping (7" X 3")
4 Communication conduit opening (2 X Ø1 3/8")
8 Anchor bolt hole (4 X Ø15/32")
888-699-6067
www.SamsungDVM-S.com