1. No category

hydrostrip 5656
Aqueous
Hybrid
Paint
Remover
Eaton’s Hydrostrip 5656 is a non-evaporative, peroxide/acid activated paint and primer remover, for removal of polyurethane and epoxy
paint systems. 5656 is designed for use on resistant films, such as fuel-resistant primers, which are not removed, or removed slowly with neutral
or alkaline strippers.
Typical Properties
Apperance...................................................................................Light-Blue Semi-Paste
Viscosity......................................................................................................20-40,000 cps
Specific Gravity..............................................................................................1.07 +/- .05
Boil/Freeze Point..............................................................................................212°F/32°F
Flash Point...............................................................................................................>212°F
Uses...................................................Effective for Most Urethane and Epoxy Systems
HAP’s...................................................................Contain No Hazardous Air Pollutants
pH............................................................................................................................4.0-6.0
Shelf Life.................................................................................................6 Months @ 77°F
Eaton Aerospace LLC,
A Division of Eaton Chemical
4124 NW Riverside Street
Riverside, Missouri 64150
United States of America
+1.800.783.7985 office
+1.816.741.0405 facsimile
www.eatonchemical.com
eaton
| aerospace |
Directions for Use
1.
A test patch is ALWAYS required prior to application on new substrates.
2.
Spray, dip, or brush 5656 onto surface to be stripped. Dwell time is dependent upon
temperature and airflow, but expect a maximum of 24 hours for polyester and polyurethane systems. Application temperature MUST be betwen 60°F and Coating thickness
also dictates dwell time.
3.
After film delamination, use a squeegee or high-pressure water spray to remove loosened coatings.
4.
Decals and other decorations may require additional applications of the stripper. In
these cases, ensure that all previously loosened coatings are removed before application.
5.
It is highly recommended that the stripped surface be cleaned with an alkaline material, such as Eaton’s 20/20 within 1 hour of stripper removal.
Precautions
1.
Always use appropriate personal protection equipment when using the product, as it is
acid-activated.
2.
All application equipment must be stainless steel or plastic, such as PVC.
3.
Used material contaminated with paint flakes and organic materials may undergo
pressure buildup from decomposition of peroxide. Paint flakes must be rinsed with
water and soap to remove paint stripper prior to packaging in VENTED CONTAINERS
before disposal. SEE MSDS FOR MORE DETAILS.
Eaton Aerospace LLC,
A Division of Eaton Chemical
4124 NW Riverside Street
Riverside, Missouri 64150
United States of America
+1.800.783.7985 office
+1.816.741.0405 facsimile
www.eatonchemical.com
eaton
| aerospace |