1page DATA SHEET PRODUCT MATACRYL CATALYST Catalyst for the curing of Matacryl Products Purpose: Application: white powder consisting of stabilized 50% dibenzoyl peroxide.is an almost odourless, free flowing, ® Matacryl Catalyst Depending on the Matacryl® products type and prevailing ambient substrate temperatures between 1 6% by weight of product should be added and is stirred in until completely dissolved. Areas : of Application Membranes and Sealers to initiate polymerisation. ® Catalyst Matacryl Primers, is mixed with Matacryl Consumption Consumption of Matacryl® Catalyst depends on the temperature at which the Matacryl® products are being applied. See separate individual Technical Data Sheets for the recommended quantities. calculate the quantity in grams and convert the result into 3 3 cm using a powder density 0.64 g/cm . The required amount of catalyst can then be measured using a If no accurate scale is available at the application site, measuring beaker: 3 3 = 1.57 Catalyst 1 ®Matacryl cm cm= 0.64 g 1 g Matacryl Packaging 25 boxes kg (Small amounts are available on request.) Shelf life originally closed packaging. Maximum storage temperature 6 months when is +25°C. stored in a cool and dry place and in Technical Data: M e >lting 54°C/ distortion temperature Powder 0,64 kg/ldensity Solubility not soluble in water Solubility highly soluble in organic solvents Thermal > 60° decomposition used. These can be obtained upon request. Such additives are necessary when application is done at temperatures above +30°C or below 0°C. To delay or accelerate polymerisation, additives can be colour pastes and thixotropic agents should be mixed with the resin before the catalyst is added. Fillers are added after the Matacryl® Catalyst is added and stirred All accelerator and inhibiting agents, pigment powders, in. ”application Systems . furtherPreparation guidelines for Matacryl “® For General details, see and our Precautions to be taken during application For Matacryl® Catalyst: Wear suitable protective clothing, gloves and safety goggles. After contact with eyes rinse immediately with plenty of water and consult a physician. After contact with skin wash immediately with water and soap. The product is an oxidizing agent; keep away from heat and all sources of ignition and do not smoke. Avoid direct contact with accelerators, e.g. Matacryl® Accelerator. For application of the Matacryl! products: Wear suitable protective clothing, gloves and safety goggles. After contact with eyes rinse immediately with plenty of water and consult a physician. After contact with skin wash immediately with water and soap. The products are highly flammable; keep away from heat and all sources of ignition and do not smoke. The mixer as well as all other electrical devices on the application site must be spark/explosion proof. For further information see our Material Safety Data Sheet. Equus Industries Pty Ltd PO Box 3424, Mornington Vic 3931 Phone: 1300 731 129 Fax 03 5973 4788 ,Email: [email protected] Web: www.equus.com.au printing, but no guarantee of its accuracy is made or implied, nor responsibility taken for use to which this information may be put. We reserve the rightinformation to alteravailable or up-date information parameters andon formulations at any time without notice. information in thisatproduct the timedata of sheet is based our experience and testing. It represents the latest The