Download Report

A-dec 361 Support Center Locking Monitor Mount
I NSTALLATION G UIDE
Recommended Tools
Install the Monitor Mount
• Hex key set
Attach the Monitor Mount to the Post
• Diagonal cutters
Before You Begin
Check with local building and code authorities about installation
requirements.
Use a SJT type cable when connecting power to the
monitor. SJT cables are more durable than the SVT cables typically
provided by monitor manufacturers and are required when routed
through moving arms. Use a monitor that weighs 20 lb or less and
accommodates either a 75 mm or 100 mm VESA pattern mount.
Always follow local building and electrical codes.
CAUTION
86.0277.00 Rev C
Use a 5/32" hex key and four 3/4" socket head screws to attach the clamp for
the monitor toward the top of the intermediate post. Position the mounting
hole for the monitor arm toward the toe of the chair.
TIP Position the monitor mount just above the cap on the post so
you can easily route the monitor cables inside the post.
Install the Monitor Arm Support
1. Use a 1/8" hex key to remove the three button head screws from each end
of the monitor arm.
3. Install the protective sheath on the cables.
4. Route the monitor cables through the monitor arm.
3
4
2. Remove the ends from the monitor mount arm.
5. Screw the ends back onto the monitor arm support.
2
6. Install the post end of the monitor arm into the monitor mount.
7. Remove the cap from the post.
8. Attach the monitor to the VESA mounting bracket using the screws
(metric) supplied with the monitor.
6
7
Screws Through Bracket Into Monitor
86.0277.00 Rev C
A-dec 361 Support Center Locking Monitor Mount Installation Guide
3
9. Route the monitor cables through the opening into the post and down into
the support center.
13.Once in the support center, bring the cables out of the opening and route
them down into the umbilical for connection in the utilities area.
10.Thread a cable tie to secure the protective sheath, pull it snug, and trim
the end.
11.Move the protective sheath up the cables so they are covered.
12.Install the new cap on the post.
11
10
Adjustments
9
Tilt Friction
Tighten or loosen the tilt friction handle located on the back left top of the
monitor mount.
12
Drift Friction
Tighten or loosen the drift friction screw located on the back right top of the
monitor mount.
Regulatory Information
Regulatory information is provided with A-dec equipment as mandated by
agency requirements. This information is delivered in the equipment’s
Instructions for Use or the separate Regulatory Information and Specifications
document. If you need this information, please go to the Document Library at
www.a-dec.com.
A-dec Headquarters, 2601 Crestview Drive, Newberg, OR 97132 USA
Tel: 1.800.547.1883 Within USA/Canada, Tel: 1.503.538.7478 Outside USA/Canada
www.a-dec.com / www.a-dec.biz
A-dec Inc. makes no warranty of any kind with regard to the content in this document including, but not
limited to, the implied warranties of merchantability and fitness for a particular purpose.
ÍvÈ.Ç"mÈ.00PÎ
86.0277.00 Rev C
Copyright 2014 A-dec Inc.
All rights reserved.
IGgrphland6