1. home and garden
2. appliances

Refrigerator:
KT55U1A132W2
KT55L1A250W1
Introduction your refrigerator
Before use
Please read these instructions carefully before using your refrigerator. The refrigerator is for indoor,
domestic use only.
KT55U1A132W2
KT55L1A250W1
Installing your refrigerator
Location
When selecting a position for your appliance you should make sure the floor is flat and firm, and the room
is well ventilated with an average room temperature of between 16ºC and 32ºC. Locate the appliance
away from direct sunlight and source of heat (stove, heater, radiator, etc.). Direct sunlight may affect the
acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause the appliance not to perform properly. This unit is not designed for use in a
garage or any other outside installation. Avoid locating the appliance in moist areas. It must therefore be
installed so that the appliance has at least 10cm (2.5”) if free space and the sides have 2cm (3/4”). The
appliance door can either open to the right or the left, depending on whichever suits you. See page 6 if
you want to reverse the door swing. Do not drape your appliance with any covering.
Moving the appliance
Position your appliance in front of its final operating position and gentle slide the appliance into position.
A minimum of two persons must be used to move the appliance.
Leveling the Refrigerator
Remove the packaging support form the base of the appliance and replace with the 2 leveling feet. Make
sure the appliance is level. Use the leveling feet at the front. If the appliance is not level, the doors and
magnetic seal alignments will be affected.
Cleaning before use
Wipe the inside of the appliance with a weak solution of bicarbonate soda. Then rinse with warm water
using a damp sponge or cloth. Wash the baskets and shelves in warm soapy water and dry completely
before replacing in the refrigerator. The external parts of the refrigerator can be cleaned with wax polish.
If you require more information refer to cleaning on page 8.
Before plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the appliance. If not, please
consult a qualified technician for assistance.
Before switching on!
DO NOT SWITCH ON UNTIL TWO HOURS AFTER MOVING THE REFRIGERATOR
The coolant fluid needs time to settle.
Getting Started
Switching on your refrigerator
1. Before connecting the refrigerator to the mains supply make sure that the thermostat control dial is set
at position 0, This is located on the right inside of the cabinet.
2. Turn the thermostat knob clockwise to set it to the desired position. Bear in mind that the higher the
number, the colder the temperature.
3. To ensure the refrigerator is cool enough to sufficiently chill your food wait 24 hours before filling with
food.
Adjusting the temperature
The internal temperature of your appliance is controlled by a thermostat. Position 7 makes the appliance
coldest. Position 1 makes it the warmest and 0 turns the appliance Off. The recommended setting for the
appliance is between 1 and 4 for colder working environments. The appliance may not operate correctly
if it is in a particularly hot or cold room or if the door is opened ofter.
Is the refrigerator cold enough?
If you are at all concerned that your appliance is not being kept cold enough, or you occasionally wish to
check the temperature, you can purchase a Fridge/ Larder thermometer. These are available from most
supermarkets and hardware shops. Place thethermometer in the coldest part of your appliance (located
at the back for the refrigerator, below the shelf), where it can be easily read. Leave overnight, the correct
temperature should be between 0ºC and 5 ºC . See 'Adjusting the temperature’.
Noise inside the refirgerator
If you have not owned an appliance before, you may notice that it makes some rather unusual noises.
Most of these are perfectly normal, but you should be aware of them.
Gurgling, whooshing
These noises are caused by the circulation of the refrigerant liquid in the cooling system. It has become
more pronounced since the introduction of CFC free gases. This is not a fault and will not affect the
performance of your refrigerator.
Humming, purring or pulsating
This is the compressor motor working, as it pumps the refrigerant around the system.
Shopping for chilled foods
Don’t buy it in your lunch hour!
Unless you have an appliance at work to keep the food cold in the afternoon, leaving food in your car or at
room temperature for a prolonged period of time could raise food temperature to dangerous level allowing
harmful bacteria to grow.
Keep chilled foods together
Try to keep chilled food together whilst shopping and on the journey home as this will help to maintain the
coldness of the food.
Use a cool bag
Special insulated bags can be bought from most supermarkets and hardware shops. These keep food
cold for longer, but are only for getting chilled foods home, not storing it.
Unwrap as soon as you get home
Always unpack and place chilled foods in the appliance before storing dry food stuffs.
In use
Tips for keeping food perfect in the refrigerator
Take extra care with meat and fish
Cooked meats should always be stored on a shelf above raw meats to avoid bacterial transfer. Keep raw
meats on a plate which is large enough to collect juices and cover it with ding film or foil.
Leave space around food
This allows cold air to circulate around the appliance, ensuring all parts of the appliance are kept cool.
Wrap up food!
To prevent transfer of flavours and drying out, food should be separately packed or covered. Fruit and
vegetables need not be wrapped.
Pre-cooked food should be cooled properly
Always let pre-cooked food cool down before you put in the appliance. This will stop the internal
temperature of the appliance from rising.
Shut the door
To prevent cold air escaping, try to limit the number of times you open the door. When returning from
shopping, sort foods to be kept in your refirgerator while the door is closed and only open it to put food in or
take food out.
NOTE: ALWAYS WRAP AND STORE RAW MEAT, POULTRY AND FISH ON THE LOWEST SHELF AT
THE BOTTOM OF THE APPLIANCE AS THIS WILL STOP THEM DRIPPING ONTO OR TOUCHING
OTHER FOODS. DO NOT STORE INFLAMMABLE GASES OR LIQUIRDS IN THE APPLIANCE.
Reverse the door swing
Ensure the appliance is unplugged and empty.
Adjust the two leveling feet to their highest position.
We recommend you have someone to assist you.
Tools required
Phillips style screwdriver
Flat bladed screwdriver
Hexagonal Spanner
Note: Take the door off it is necessary to tilt the refrigerator backward. You should rest the refrigerator on
something solid and place something under the rollers so that it will not slip during the door change
process.
DO NOT lay the refrigerator completely flat as this may damage the coolant system.
Cleaning
Cleaning the outside of the refrigerator
Use standard furniture polish to clean the appliance exterior. Make sure that the door is closed, to prevent
polish getting on the magnetic door seal or inside on to the food. Do not harsh cleaners, scouring pads or
solvents to clean any parrot of your appliance, as this my scratch the enamel.
Cleaning the inside of the refrigerator
Make sure the refrigerator has been turned off at the mains before cleaning. The inside of the refrigerator
can be cleaned with a weak solution of bicarbonate of soda. Rise with a damp sponge and wipe dry.
Reconnect to the mains supply.
Cleaning tips
Defrost when food stocks are low.
NOTE: Do not use harsh cleaners, scouring pads or solvents to clean any part of the refrigerator.
Maintenance
Moving your Refrigerator
Care when handling
Hold the refrigerator around its sides or base when moving it. Under no circumstance should it be lifted by
holding the edges of the top surface.
Location
Do not locate your refrigerator near a heat source, eg. cooker, boiler or radiator. Also avoid direct sunlight
in outbuildings or sun lounges.
Changing the Internal Light
1. Befroe carrying out the bulb replacement always press and turn the thermostat control dial to Position 0,
then disconnect the mains supply.
2. Hold and uncrew the light bulb cover..
3. Remove the plastic light bulb cover
4. Remove the old bulb by unscrewing in an anti-clockwise direction.
5. Replace with a new bulb (10W SES), please make sure that it is secure in the bulb cover.
6. Refit the translucent light cover and reconnect your refrigerator to the mains supply and switch on.
Leveling the Refrigerator
Make sure the appliance is level. Use the rotating leveling feet at the front. If the appliance is not level,
the doors and magnetic seal alignments will be affected and may cause your appliance to work incorrectly.
Do Not Turn on the Freezer for 2 Hours
After the appliance has been placed, it needs to be left alone for 2 hours. The coolant fluid needs time to
settle.
Servicing
Repairs and maintenance of the appliance should only be performed by an authorized, qualified
technician.
The refrigerator is not working
--Check it is plugged in and switched on.
--Check that the fuse in the plug, has not blown.
--Plug in another applianjce, such as lamp to see if the socket is working.
Condensation appears on the outside of the refrigerator
This may be due to a change in the room temperature. Wipe off any residue of moisture. If the problem
continues call the customer service department.
Noises
You may hear some unusual noise from time to time. See ‘Noise inside the appliance’ on page 3.
However if your appliance begins to make noises you have not heard before call the Customer Service
Department.
Safety
WARNING!
It is hazardous for anyone other than authorized service personnel to carry out servicing or repairs which
involves the removal of covers.
To avoid the risk of an electric shock do not attempt to repair this appliance yourself.
Disposal
Old appliances still have some residual value. An environmentally friendly method of disposal will ensure
that valuable raw materials can be recovered and used again. The refrigerant used in your appliance and
insulation materials require special disposal procedures. Ensure that none of the pipes on the back of the
appliance are damaged prior to disposal. Up-to-date information concerning options for disposing of your
old appliance and packaging from the new one can be obtained from your local council office.
Locks
If your freezer is fitted with a lock, to prevent children being entrapped keep the key out of the reach and
not in the vicinity of the appliance.
If disposing of an old freezer break off any old locks or latches as a safeguard.
Weight and Dimensions are approximate. Because we continually strive to improve our products we may
change specifications and designs without prior notice.
This symbol on the product or in the instructions means that your electrical and electronic equipment
should be disposed at the end of its life separately from your household waste. There are separate
collection systems for recycling in the EU.
For more information, please contact the local authority or your retailer where you purchased the product.