1. No category

Thank you for purchasing the AV3018 Cage. The following will be a detailed and
photographed set of instructions of assembly for your convenience. Prepare to assemble
your product in 4 easy steps.
Step 1 – Check Materials
Your product will be contained in a large cardboard box, proceed to open and sort out the
contents.
Make sure you have all the following:
• Cage Front (1)
• Cage Rear (1)
• Cage Sides (2)
• Cage Roof (1)
• Cage Bottom Shelf (1)
• Cage Bottom Grill (1)
• Cage Tray (1)
• Cage Stands (2)
• Cage Stand Brace (1)
• Pack of Wheels & Screws (1)
• Box of Feeding Cups (1)
• Wooden Perch (4)
• Reference Photo (1)
Part 2 – Constructing the Stand
The first step will be to put together the stand. First gather the two stands, the supportive
brace, and the bottom shelf.
Note! The bottom shelf is distinguishable from the other pieces due to the screw holes
that it has.
If you have all these parts, proceed to first attach the stands with the bottom shelf by
lining up the screw holes.
There are 3 types of screws included with your package in a small bag. For the stand, you
will need to use the screw with the fastener at the end. Proceed to attach the two stands
with the bottom shelf screw by screw.
After this, begin to attach the supportive brace for the cage. The brace is the piece with
the circular decorations around its corners. Before proceeding, make sure the circles are
facing upward.
The brace has holes around each corner next to the circles for attachment to the stands.
For this attachment you will need to use the other four thicker screws:
Line up each hole on the upper portion of the brace and attach the screws thoroughly. The
end result should look like this:
The final step of the stand construction is to then add the wheels to each of the legs.
Simply remove the wheels from the bag and shove its rod into the bottom holes of each
leg until the wheel connects securely. Twist while inserting wheel if necessary.
Step 3 – Constructing the Cage
You have finally constructed the stand! Now it is time to build the main portion – the
cage itself. This portion will be easiest if you start off building the cage from its rear. So
start with the rear and the cage’s sides. Each vertical side of the cage will have 3 screw
holes around each corner. For this portion, you will be using the silver screws for
attachment.
The sides have to be lined up accordingly to each screw whole before attaching it to the
rear. Note – Leave the horizontal screw holes alone until the sides are connected.
When you are done attaching the sides to the cage rear it should look similar to this.
Make sure that there is a screw securely in place for each vertical hole.
Then, proceed to attach the cage front to the two remaining sides.
Next, proceed to attach the cage roof to each side. Each side of the cage will have 2
horizontal screw holes for attachment. Screw in each side securely.
This should be your end result, make sure to check again if the screws are securely in
place.
Next you may choose to in the feeding cups and perches. The cups go accordingly to
each little gate in front. The perches go subjectively in the cage but must be evenly
placed between the bars.
Step 4 – Attaching the Cage to its Stand
The cage should fit snugly over the stand’s upper supportive brace. It would fit
accordingly around the corners with the circular pattern as shown:
With the cage attached to the stand. It is now time to add the remaining levels of the cage.
Add them accordingly as shown below:
Cage grill
bottom tray
Congratulations, you have successfully assembled your AV3018 cage!
For any questions or concern please contact us at:
YML Group Inc.
626-442-4975
www.ymlgroup.com
[email protected]