1. No category

82 333 410
ASTRO Strobel
Kommunikationssysteme GmbH
Olefant 1–3
D-51427 Bergisch Gladbach (Bensberg)
Tel. 0 22 04 / 4 05-0
Fax 0 22 04 / 4 05-10
http://www.astro-kom.de
email: [email protected]
Operation instructions
X-BC 3
X-BC Buscontroller
X-BC Buscontroller
Summary
Technical Data
This head-end bus controller is used for central adjustment of all bus-capable
head-end devices via PC or laptop. At the same time it can also be used for
maintenance or reprogramming of set-up head-end units via modem.
Order reference
330 40
Power supply
6 V DC via plug-in power supply (230 V~ / 50 Hz)
The device can only be operated by means of the HE programming software!
Current draw
35 mA
Features:
Permissible temperature range
Actuation of up to 240 bus-capable head-end units
Operating software can be updated via the serial interface (meaning that no
installation/removal work is required for software upgrades)
Bell signal up to call acceptance can be individually adjusted
(meaning that no installation/removal work is required for software upgrades)
8-digit identification code protects against unauthorized remote access
Control of cross-module allocation of time-sharing
Automatic fault notification via GMS
Internal monitoring timer protects against expensive telephone costs
(automatic disconnection after 5 minutes if communications are inactive)
Housing (W x H x D)
Illustration
-15 °C . . . +50 °C
86 x 40 x 145 mm
Data bus
Telecommunications
Handheld
Modem
optional
KC 3
RS-232
PC / laptop
green LED
Betrieb is illuminated:
Buscontroller is
operational
green LED
Online is illuminated:
Online connection has
been established via
the modem
X-BC red LED
Störung is illuminated:
Internal fault
(hardware fault)
Fault on the
bus system
DC jack:
Plug-in power supply
Bus port:
X-5 twin oder V16
data bus line
RS-232 port:
PC oder laptop
Modem port
for remote control of
the head-end unit