HOW TO ASSEMBLE – MDHA485 BOOM STAND


Hold the black sleeve in place with the thermal head and tighten the side handle.
Side
handle
Thermal head
HOW TO ASSEMBLE
BOOM STAND – MDHA485
TUTORIAL
Fine tuning Z-Axis

Rotate the Z axis hand wheel's tension to fine tune the plunger contact with the device.
Z axis hand
wheel's tension
Plunger
DUT

Slide the horizontal pillar with cross block into the vertical post.
www.mechanical-devices.com
MECHANICAL DEVICES, 34 Ha'amelim Street, Haifa Bay, 2624409, Israel, Tel: 972 4 8490793,
[email protected]
DOC 13000186-4
Package layout

The Boom Stand is packed with parts laid out as shown in figure 1.
Stopper
Fig. 1


Horizontal pillar
Insert the e-arm into the end of the horizontal bar and tighten using lock wheel
E-arm can be inserted from the TOP, or BOTTOM of the horizontal bar. Set e-arm
up at various angles and tighten the lock lever for prefect oblique viewing.
Assembly

Place the clap stand at the side of the table and screw the cap tightly.
E-Arm
Clap stand