F10 MOTORIZED FLOW CONTROL to 15 GPM Function: Motor Driven Flow Control Cartridge for restrictive type flow control, non-pressure compensated. Two wire flying leads (std). Energize with 12 VDC to adjust flow. Change polarity to open or close valve, cut 12 VDC power to hold valve at desired setting. All that is required for basic control is a DPDT switch. M M Applications: Any circuit requiring electric remote control of hydraulic flow such as remote flow control of a load sense (pressure and flow compensated) pump. See schematic on right. Available Flow Ranges: • 0 to 3 GPM Bidirectional • 0 to 5 GPM Bidirectional • 0 to 10 GPM Bidirectional • 0 to 15 GPM Bidirectional Operating Speeds: • 1 second to 48 seconds for switch control • 1 second for microprocessor controllers • Manual override std. • See motor specification sheet for details. Electrical Characteristics: • 12 VDC (9-15 VDC) std, 24 VDC (18-30 VDC) optional • Momentary surge up to 2 amps for 12V, 3.75 amps for 24V • Fuse @ 2 or 4 amps depending on voltage. Operating Pressure: • 3000 psi maximum (consult factory for higher pressures) Cavity: 10-2 Industry Common Cavity (SAE #10, 7/8-14) Temperature: -40 to 100 C Installation: Torque at 35 ft-lbs Costruction: • Cartridge body and spool: steel • Sealed Motor Container: Anodized Aluminum • Exposed Parts Plated Available Operations: • Resistive Position Feedback • Electronic Controller Packages • Proportional Driver Interface • Line Manifolds • Consult factory for details Select Flow Range: 0 to 3 GPM 0 to 5 GPM 0 to 10 GPM 0 to 15 GPM F10 ** * ** ***** ** Select Operating Speed: See motor Specification sheet on Appendix page 1. Check for speed and operating voltage (12 or 24) Options: _ _ Std 18'' flying leads leave blank. ** See appendix page 2 for available options 2.00 7.50 1.125 HEX 7/8-14 THREAD 1.25 FLOW FLOW HOW TO ORDER Manifold: __ No Manifold, leave blank 10182 Standard body line, SAE #8 10182LS Body with Load Sense Port, SAE #10 Consult Factory for Other Options Source Fluid Power - Phone: 952-368-3866 - Fax: 952-448-3392 - Sourcefp.com Function: Two port motorized flow control package with pressure compensating element. Applications: Pressure compensated restrictive type flow control typically used with pressure compensated pumps and in circuits requiring constant flow under varying load conditions. Operating Pressure: • 3000 psi maximum. Flow Range: • • • • 0-3 GPM. 0-5 GPM. 0-10 GPM. 0-15 GPM. Body material: • Anodized Aluminum.
© Copyright 2024