How To Replace Cabin Micro Filter (2) – BMW X5...

How To Replace Cabin Micro Filter (2) – BMW X5 E70
P/N: 64119248294X5
01
01
01
02
03
04
05
06
Set, microfilter
X6 35iX (N54). Required: 1
Set, microfilter/activ. charcoal filter
X5 4.8i (N62N). Required: 1
X5 M (S63). Required: 1
Set, microfilter/activ. charcoal filter
X5 3.0si (N52N). Required: 1
X5 3.5d (M57N2). Required: 1
Microfilter, recirculated air
X5 4.8i (N62N). Required: 1
Housing, microfilter, upper part. LHD
X5 3.0si (N52N). Required: 1
Frame seal, firewall, inner. LHD
X5 3.0si (N52N). Required: 1
Hex nut. BM6-8-ZNS3
X5 M (S63). Required: 4
X5 4.8i (N62N). Required: 4
Hex bolt with washer. M6
$72.10
64316945585
$102.83
64119248294
$99.62
64316945586
$28.33
64319194098
$32.19
64316945575
$40.44
64316945581
$0.75
07129904859
$0.94
07146954299
07
08
09
10
11
11
12
13
X5 3.0si (N52N). Required: 6
Cover for housing, microfilter, right
X6 35iX (N55). Required: 1
X6 M (S63). Required: 1
Cover for housing, microfilter, left
X5 50iX (N63). Required: 1
X6 35iX (N55). Required: 1
Air duct. LHD
X5 3.5d (M57N2). Required: 1
X5 4.8i (N62N). Required: 1
Screw, thermoplastic plastics. NS-TS5X20-ZNS3
X6 50iX (N63). Required: 2
Filtered air duct
X5 4.8i (N62N). Required: 1
X5 50iX (N63). Required: 1
Filtered air duct
X5 50iX (N63). Required: 1
X6 35iX (N55). Required: 1
EXPANDING RIVET
X6 M (S63). Required: 1
X5 M (S63). Required: 1
Rotary clip
X5 3.0si (N52N). Required: 7
X6 35iX (N54). Required: 7
$28.65
64316945584
$28.65
64316945583
$9.69
64316945579
$0.52
07129904960
$21.78
64319175465
$15.75
64316945577
$0.29
51111908077
$2.52
64316933306
Unplug the electrical connect to the smell sensor by pushing on the clip while pulling the
connector
1) Ensure the filter elements are oriented properly: they have an arrow indicating the direction
of the airflow. As you mount them in the housing the arrow points towards the inside of the
housing. You can't put them in the wrong way because the clips won't allow you
2) Ensure all 4 clips on each filter elements have set
3) Don't forget to plug back in the electrical connector for the smell sensor
4) When you put back the windshield trim cover ensure that the water drain is correctly placed
into the fender: you first insert the water drain passage and the hood lift shock, then lower it