1. No category

How to Install Inspire RGB LED Tape Light
Step 1) Measure Area for LED Tape Light
Use a measure tape to measure each of the areas you want to put Inspire RGB LED Tape Light.
Step 2) Select Correct Driver to Power Inspire RGB LED Tape Light
Use this simple calculation to figure out how large of a driver you need to use:
Run Length x Tape Light Wattage (per foot)
(Measured
in step 1)
=
Total Watts
Inspire RGB LED Tape Light is 4.32 watts/foot
(Correct driver must be able to
power at least this amount of watts)
Example: 14 Foot Run Length x Inspire RGB LED Tape Light (4.32 watts/foot) = 61 Watts
You need a driver that can power at least: 61 Watts
Step 3) Make Sure to Stay Within the Max Run Length Limits
There is maximum amount of feet of Inspire RGB LED Tape Light that can be plugged into together in one continuous
run. DO NOT exceed the maximum run length limits. You will void the warranty and possibly damage the tape light.
Inspire RGB LED Tape Light
16 Foot Max Run Length
NOTE: You can power more than one run of LED tape light by wiring multiple hardwire connectors (#CON-HW-RGB)
into the same driver.
Step 4) Connect Everything Together - Sample Wiring Diagram
120V
AC
Electronic
Hardwire Driver
RGB RF
Controller
Black 120VAC
Black 120VAC
Red +24VDC
Red +24VDC
White 120VAC
White 120VAC
Black -24VDC
Black -24VDC
Green Ground
Green Ground
Low Voltage Connections
#CON-HW-RGB
Hardwire Connector
Match + Symbols
Black +24VDC
Red –24VDC
Green –24VDC
Blue –24VDC
Line Voltage Connections
Inspire RGB LED Tape Light
Black +24VDC
Red –24VDC
Green –24VDC
Blue –24VDC
RGB Connections
Optional: Cut the Inspire RGB LED Tape Light
You can cut the Inspire RGB LED Tape Light only on the cut marks. See the example below:
Cut Here
Cut Here
NOTE: Once you cut the polyurethane coated Inspire RGB LED Tape Light you cannot re-attach more tape light to
continue your run.
www.ledinspirations.com
[email protected]
Phone: (832) 717-2710
11744 Grant Road
Fax: (866) 523-0169
Cypress, TX 77429
v1