How to Configure the V220

How to Configure the V220
•
•
•
•
First you should have some Information from your VoIP service provider:
1. VoIP Username
2. VoIP Password
3. Sip Proxy Server/Domain Name
4. Codec
Now Connect your V210P to your computer using an ethernet cable from the computer
to the LAN port of the VoIP ATA. The WAN port of VoIP ATA should be connected to
the ADSL/cable modem or router (Internet Source).
Navigate to http://192.168.22.1/ in a web browser.
Enter “admin” as the username and “admin” as the password (without quotes) and
then Press ‘Login’.
•
The V220 System Information page should appear. Click on “VoIP” on the left hand
side and then click on “SIP Service Provider”.
•
The SIP Settings will appear. Enter the information in the required fields as given by
your VoIP service provider such as username, password, etc. First select “Phone 1”
phone number drop down menu and then complete in the required information.
1.
2.
3.
4.
5.
SIP Proxy Domain:
Your VoIP proxy address
Proxy Server:
Your VoIP proxy address
Display Name:
Your VoIP username
User Name:
Your VoIP username
Auth. ID:
Your VoIP username
6.
7.
•
•
Auth. Password:
Your VoIP password
SIP Expire Time:
240
Now press “Submit” at the bottom of the page to apply the settings.
If you also wants to configure “Phone 2”, select “Phone 2” in the drop down menu
and then fill up the information for phone 2 otherwise proceed to NEXT step.
1.
2.
3.
SIP Proxy Domain:
Your VoIP proxy address
Proxy Server:
Your VoIP proxy address
Display Name:
Your VoIP username
4.
5.
6.
7.
•
User Name:
Your VoIP username
Auth ID:
Your VoIP username
Auth Password:
Your VoIP password
Expire Time:
240
Now press “Submit” at the bottom of the page to apply the settings.
•
•
Now click on “Save Settings/Reboot” and then click on “Save & Reboot”. It will
save you settings in the VoIP ATA and reboot it.
After rebooting the VoIP ATA check the status on lights on it. SIP light should turn ON.
That means you are connected to your VoIP service provider. You can also check
within the VoIP ATA by clicking on “VoIP Status” on the left hand side. It will show
you the information as per your setup you have done whether you have configured
one phone or two.
•
Now your VoIP ATA is properly configured and you can plug in the phone set in the
ATA and check the dial tone.