Users manual muudi dimmer Art no SM07 Type Electronic, wall box installation. Function Push on/off, turn for dimming. Terminal block 2,5 mm2 Fuse electronic Input max 230V, +- 10%, 50Hz EMC approval EN55015 Class 2 Ta max 40 degree C Tc min -20 degree C 1) Min load Watt Max load Watt Incandescent lamp ohm (not halogen) 35 600 230V halogen bulbs 35 500 12V AC transformer 35 600 Load Gu10/G9 LED bulbs 10 300 LED drivers *) see below 10 300 LK drivers tracks/seiling lamps 6W 300W LK/NX dimmable GU10/G9 bul bs 3W 300W General Electric 5W dimmable GU10 5W 300W 10W 300W 3700800 Etman GU10 5 W 5W 300W 3330187 Lumens downlight 7,5W 7,5 300W 3230177 Lumens GU10 5 W ETM Øst GU10 7 W (long) 5W 7W 300W 300W *) Philips LED driver/SG COB Junistar Ex 1) Loads above refer to 25 degree C temperature, if higher room temperature load must be reduced. If several dimmers are mounted vertical above one another, loads must be reduced according to illustration below. In case of overload the fuse cut off 100%. Seek for the fault, before testing again main fuse for the 230V shall be cut off and switched on again (ensure electronic fuse in dimmer to re-start). Minimum and maximum load refer to the most common fabricates in the marked, exception may occur. Therefore always refer to bulb/lamp supplier for recommended dimmer. Installation only by authorised company/installer. 100 90 80 70 60 50 40 30 20 10 0 -10 0 10 20 30 40 50 60 70 80 90 100 Extra on/off Swith 230V 50HZ L N SD400/SD600 12V on/off Swith vender 230V 50HZ L N SD400/SD600 12V Electronic transformer 12V Electronic transformer 12V Electronic transformer Electronic transformer