How to make the d8b PSU/CPU fanless Do this only if you know what you are doing and if you want to use your d8b as a pure DAW controller ! Warning: you will loose the Audio functionality of the d8b Warning: check if you have the 230V or the 110V CPU/PSU. You need the right 12V fanless switching power supply for that. Order SNT MW60-12 :: Schaltnetzteil, geschlossen, 12V / 5,0A / 60W www.reichelt.de http://www.reichelt.de/Schaltnetzteile-Case-geschlossen/SNT-MW6012/3/index.html?&ACTION=3&LA=2&ARTICLE=57482&GROUPID=4959&artnr=SNT+MW60-12 or similar (check if you need a 110 (US) or 230V EU version) 1. Disconnect the 230V/110V site of the Compute Power supply 2. Disassemble the computer power supply and disconnect ALL connectors. This will make the CPU dead. Remove computer power supply. IMPORTANT ! Also disconnect the plug “A” in the picture downwards. Cut this connecter from the power supply in a way that you have the most possible cable length! You will need this cable for the new power supply. Also disconnect the connector “B” (brown and blue cable). B A 3. Mount the new fanless 12V power supply to the location of the old computer power supply. 4. Connect the primary 230/110V connectors to the connector “B”. blue is N, brown is phase L (110V/230V). Change the fuse F1 to a fitting value for your new power supply !!! if the supply has a fuse build in you can short the fuse F1. B 5. Connect the cable that you have cutted from the computer power supply to your new fanless 12V supply. Yellow should be V+ (12V) the black cables should be GND. 6. Plug the cable back to the connector “A” A A A