Wall Ties – WT series © Copyright 2013 USP Structural Connectors® Materials: 22 gauge Finish: G90 galvanizing Options: WT22 is available in Stainless Steel. To order, add SS to stock number, as in WT22-SS. 1 ˝ space between brick and sheathing Installation: • Use nails appropriate for intended use. • The opposite end must be bonded in the mortar joint of brick facade. • Check local codes for spacing requirements. • Wall tie shall be bent at nail, bonding into mortar joint. • Meets prescriptive requirements of CSA A370-04 for corrugated strip ties. USP Stock No. WT17HD-75 WT22 Steel Ref. No. Gauge -- -22 BTB 22 Dimensions (in) W 1 7/8 L 7 6-1/2 Typical WT installation 1,2 Fastener Schedule Qty 3 1 Type 10d 10d W 1) Minimum nail embedment shall be 8 nail diameters (typ). 2) NAILSGQDLOVDUHÝGLD[ÝORQJ L WT Angles – ML series ML angles are multi-purpose angles that install easily with USP’s WS15 wood screws. The staggered fastener pattern allows for back-to-back installations. Materials: 12 gauge Finish: G-185 galvanizing NEW Load Direction Installation: • Use all specified fasteners. See Product Notes, page 10. • USP WS15 (1/4″ x 1-1/2″) are not supplied with ML angles. W Fastener Schedule2,3 Dimensions (in) USP Stock No. ML24-TZ ML26-TZ Ref. No. ML24, ML24Z ML26, ML26Z Header W H Qty Type Qty Type 12 2 4 3 WS15 3 WS15 12 2 6 4 WS15 4 WS15 W Factored Resistance1 Joist Steel Gauge Miscellaneous Typical ML26-TZ installation (ML24-TZ similar) DF-L (Lbs) Unit Lbs kN Lbs kN 100% 1100 4.89 1890 8.41 115% 1265 5.63 2175 9.68 S-P-F (Lbs) 100% 780 3.47 1340 5.96 1) Factored resistances have been increased 15% for short duration loading; no further increase allowed. 2) USP's WS15 Wood Screws are 1/4" diameter x 1-1/2" long and are not included with angles. 3) For exterior applications use WS15-GC screws with the Gold Coat finish New products or updated product information are designated in red font. 1-800-328-5934 • www.USPconnectors.com 115% 900 4.00 1545 6.87 H ML26-TZ (ML24-TZ similar) USP2240-131 201