1. No category

Watch Ashley make origami
at womans.org/3D. To add a
dimension of your own, make
your own origami and share on
social media using #womans3D.
1. Start with a square piece of
paper, printed side up. Fold
in half and open. Then fold
in half the other way.
4. Fold the top triangular flaps
into the center and unfold.
7. Turn the model over
and repeat steps 4-6
on the other side.
11. Inside reverse fold the
“legs” along the creases
you just made.
Crane
2. Turn the paper over to the white side. Fold
the paper in half, crease well and open, and
then fold again in the other direction.
5. Fold the top of the
model downwards,
crease well and unfold.
8. Fold the top flaps into the center.
3. Using the creases you have made, bring the top
three corners of the model down to the bottom
corner. Flatten model.
6. Open the uppermost flap of the model, bringing it
upwards and pressing the sides of the model inwards
at the same time. Flatten down, creasing well.
9. Repeat on the other side.
12. Inside reverse fold the “legs”
along the creases you just made.
10. Fold both “legs” of the
model up, crease well,
then unfold.
12. Finished crane!
Watch Ashley make origami
at womans.org/3D. To add a
dimension of your own, make
your own origami and share on
social media using #womans3D.
1. Start with your paper white side up.
Fold in half, as shown.
4. Turn the model over and fold the bottom
corner up to the top corner. Crease well.
7. Raise the inside triangle upward
slowly, then flatten and crease well.
2. Fold the outside corners into
the center line and crease well.
5. Fold in half.
8. Inside reverse fold the head
along the crease shown.
Pelican
3. Fold into the center once again.
6. Rotate the model.
9. Fold each wing upward
as shown, then open out
slightly. The pelican will now
rest on its wings and sit up.
10. Finished pelican!
Watch Ashley make origami
at womans.org/3D. To add a
dimension of your own, make
your own origami and share on
social media using #womans3D.
Pine Tree
1. Start with a square piece of paper, colored side up. Fold the paper in
half, crease well and open, and then fold again in the other direction.
2. Turn the paper over to the white side. Fold the paper
in half, crease well and open, and then fold again in the
other direction. Your creases should look like this.
3. Using the creases you have made, bring the top three corners of the model down to the bottom corner. Flatten the model.
4. Fold toward the center
line and unfold.
8. Fold the whole model along
this crease and unfold.
5. Using the crease you have just
made, open and flatten this flap.
6. Repeat step 4 and 5
on the other three
flaps of the model.
9. Fold each full-color flap
backward underneath itself.
7. Now make sure there are
equal flaps underneath the
model, and that the top flap is
showing full color, like this.
10. Now you can adjust your pine
tree so it is even all the way
around, and it stands up by itself!