Modular Air Handling Unit Range 0 to 3,600 Litres / Sec Description The compact design of the MINItherm ranges of fan coil units make them ideal for use in ceilings or plant rooms that have limited space. Units incorporate double skin 50 mm polyurethane panel construction that complies with National Construction Code insulation specification J5.2 (all areas except for Alpine areas.) Units are available in low profile, horizontal or vertical configurations. The HMEL range features a low height of only 800mm and is ideal for mounting in ceiling spaces. The HMEP range features a horizontal configuration and discharge and is suited to floor or ceiling mounting in a plant room. The VMEP range features a vertical configuration and discharge and is suited to floor mounting in a plant room. The VMEP range also offers a minimum footprint size on the plant room floor. Features  Double skin 50 mm polyurethane panel constructions that complies with National Construction Code insulation specification J5.2.  Casing has a high resistance to cold tracking and condensation. Modular casing construction achieves TB2 thermal bridging rating as defined in BS EN1886:2007.  Matching filter plenums are available.  High efficiency EC plug fans with integral speed control, current overload and motor phase protection, reverse polarity and locked rotor protection and soft starting.  EC Plug fans can be run independently or integrated into most building management systems. Fans can be controlled by MODBUS and 0-10V.  EC plug fan motors exceed EU’s minimum level of efficiency for electric motors (IE4).  Fan motors prewired to a junction box and commissioning speed controller located on the coil pipe side adjacent to the fan discharge.  Chilled water cooling coils available with 3,4,5,6 or 8 rows and 315,394 or 472 fins/metre.  Hot water heating coils available with 1 or 2 rows and 394 fins/metre.  Maximum combined cooling and heating coil number of rows is 8. Typical applications Commercial and industrial applications including: Shopping centres, office buildings, hotels, health facilities, schools and universities. Construction Units incorporate modular thermally broken, aluminium frame construction with double skin, 50mm thick, polyurethane filled panels. Each unit is complete with an access panel on the coil pipe each side allowing for the necessary inspection and cleaning. The condensate tray is of a non-ponding design manufactured from grade 304 stainless steel. Fans are high efficiency EC plug type in a single or dual arrangement depending on the model. Motors     EC motors are 3 phase 415V 50-60Hz. Bearings are sealed for life ball type. Integrated EC controller providing infinite speed control. Type of protection-IP54 Suggested Specification Units shall incorporate modular thermally broken, aluminium frame construction with double skin, 50mm thick, polyurethane filled panels achieving TB2 thermal bridging rating as defined in BSEN1886:2007. Cooling and heating capacities and external static pressures shall be as shown on the schedule. Fans shall be backward curved centrifugal type driven by EC motors complying with IE4. Fans must be prewired to an external terminal box and commissioning speed controller.