ESP8266 Breadboard adaptor with flash switch and reset button Model 8266BBA01 2/13/15 The 8266BBA01 ESP8266 Breadboard Adaptor makes it easy to connect the ESP8266 to a breadboard or standalone for programming and testing. An 8 pin 0.1 inch pitch terminal is available in the bottom to directly connect to a breadboard. An 8 pos screw terminal is available to get access to all the ESP8266 pins without soldering. A 2x4 socket makes it really easy to switch ESP8266 modules for quick testing and programming. Snaptekk – www.snaptekk.com -‐ Houston, TX A 2x4 socket is provided for convenient pug-‐in of the ESP8266, making it really easy to test and program many boards. Flashing the ESP8266 To flash the ESP8266, connect the serial RX and TX to your serial to USB board, plug the jumper, reset the board and start the flashing software. If Flashing software fails, cycle power down and up, reset and try again. Get this document in PDF at http://www.snaptekk.com/Esp8266_Breadboard_v01.pdf NOTE: ESP8266 module not provided with the board. Snaptekk – www.snaptekk.com -‐ Houston, TX