1. No category

Part №:
Product:
449 Heads Road, Wanganui 4501
0800 4 BULLBARS or (06) 344 4100
[email protected] www.aliarc.co.nz
F558
REAR GUARD
FITTING INSTRUCTION SHEET
Make:
Model:
Year:
Ford
Ranger 4WD XLT Sensor Bumper
Fits AB39-19E544-CG Towbar
2012-
KIT CONTENTS
Quantity
2
1
1
Product
Checklist
Alloy Bumper Spacers
Product Warranty Sheet/Customer Feedback Form
F558 Fitting Instruction Sheet
For all other Bolts – use originals.
INSTRUCTIONS
1. Remove Towbar Tongue, unplug bumper wiring
and remove bumper (1 x R clip, 2 x wiring plugs
and 4 x bolts).
For technical assistance phone 0800 4 BULLBARS
Page 1 of 2
2. Remove bumper side arms and refit with alloy
Spacer Plates.
3. Position Rear Guard around bumper and refit
to vehicle as one unit. Refit the 4 bolts and
reconnect the wiring plugs. Align bumper and
Rear Guard.
Tighten all bolts and refit Towbar Tongue.
NOTES








Check that the Kit contents are complete and undamaged prior to installation. Kit contents
must be replaced with specified accessory components.
Do not use the Rear Guard as a step. Use the original step bumper. Improper use may
result in injury.
Do not attach the bar to the vehicle using anchorages not intended for this purpose.
Do not use the bar for any vehicle other than those specified by the bar manufacturer.
Do not remove any labels from the bar.
Do not modify the structure of the bar in any way.
We recommend that a rust preventative is applied where holes are drilled.
The use of an alloy polish such as ‘Auto Sol’ is recommended for extra shine, however hot
soapy water will also clean well.
For technical assistance phone 0800 4 BULLBARS
Page 2 of 2