Connecting the AngelTrax Security Key to your Hard Drive
INSTALLATION Connecting the AngelTrax Security Key to your Hard Drive CONNECT SECURITY KEY TO HARD DRIVE: Playback Station hard drive 1 DVR wide segment narrow segment hard drive CONNECT SATA PLUG 2 secondary USB hard drive security key SATA SATA Connector REMOVE HARD DRIVE primary USB INSERT USB PLUGS Included in your DVR shipment is a black cable with two USB connections on one end and a wide SATA connection on the other. This is the AngelTrax Security Key used to connect the DVR’s hard drive to the playback station for reviewing and downloading data. Please follow the instructions below to connect the AngelTrax Security Key to your DVR’s hard drive and your playback station. Refer to the above diagrams for proper connection. If you have any questions, please contact AngelTrax Tech Support at 334-692-4600 or toll free at 800-673-1788 and ask for Tech Support. REMOVE HARD DRIVE Remove the hard drive from the DVR. CONNECT SECURITY KEY TO HARD DRIVE Note: The SATA connection must be connected to the hard drive FIRST before connecting the hard drive to the playback station. The playback station will NOT read the hard drive if the USB connections are plugged in first. On the back of the hard drive (the end that connects to the DVR) is a black SATA connector with two segments, one wide and one narrow. Insert the wide end of the security key cable, labeled SATA, onto the black bar on the hard drive until it snaps into place. CONNECT PRIMARY AND SECONDARY USB Insert the primary USB connection (with long cable) into an available USB port on the playback station. If an additional USB port is available, insert the secondary USB connection (with short cable) into the port. This provides extra power to the DVR for a faster hard drive connection to the playback station. 01/2015 -- How to Install the Security Key 1.800.673.1788 | www.angeltrax.com Page 1 of 2 INSTALLATION Connecting the AngelTrax Security Key to your Hard Drive CONNECT SECURITY KEY TO HARD DRIVE: Playback Station Security Key SATA 2 1 primary USB power light DVR secondary USB hard drive hard drive SATA 3 CHECK POWER LIGHT hard drive UNPLUG HARD DRIVE REPLACE HARD DRIVE Please follow the instructions below to connect the AngelTrax Security Key to your DVR’s hard drive and your playback station. Refer to the above diagrams for proper connection. If you have any questions, please contact AngelTrax Tech Support at 334-692-4600 or toll free at 800-673-1788 and ask for Tech Support. CHECK POWER AND ACCESS LIGHTS Above the SATA connection a red “Power” light will indicate the hard drive is receiving power. A blue “Access” light will flash to indicate the hard drive is accessible to be read. DISCONNECT HARD DRIVE • At the bottom right of your computer screen, select the USB icon and click “Safely remove hardware and eject media.” • Unplug the secondary USB connection (if used) first. • Unplug the primary USB connection. • Unplug the SATA connection from the hard drive. RETURN HARD DRIVE Return the hard drive to the DVR or place it in your archiving location. 01/2015 -- How to Install the Security Key 1.800.673.1788 | www.angeltrax.com Page 2 of 2
© Copyright 2024