to supplimentary manual for 100W Coil

AUBER INSTRUMENTS
WWW.AUBERINS.COM
Instruction Manual
RDK-100/110/200/300 Supplementary Manual for 100W Coil
Version 1.3 (April, 2015)
1. Introduction
Table 2. Parameters in RDK-200 under access code “166”.
The initial parameters in the RDK-100/110/200 controller are set for 250W coils.
When a 100W Coil (Flat Coil, 20mm Coil, 15.8mm Coil w/ black Kevlar
sleeve), rated as 100W under 120VAC, is used with these controller, some
parameters should be adjusted to achieve good temperature control.
2. For RDK-100/110
Press SET key once, enter access code “0036”. Then press SET again. You
will enter parameter settings. For 100W Coil, please set P value to 2.0. Other
settings should remain unchanged. Please see Table 1. For 250W Coil, you
should keep the P value to 5.0 (default value). Please refer the flow chart
below for details.
Description
Proportional band (in 0.1 degree)
Integral constant (second)
Derivative constant (second)
Output high limit
Description
Range
Initial
Knob
Knob
P
p
Proportional band (in 0.1 degree)
0-999
5.0
I
I
Integral constant (second)
0-999
40
lck
166
Knob
d
d
Derivative constant (second)
0-999
10
souf
SouF
Damp Constant
0.1~1.0
0.4
ot
ot
Cycle Rate
2-199(sec)
2
p
125
filt
FILT
Digital Filter Strength
0-3
0
Knob
End
End
Exit
SET
Enter Code
XXXX
0036
SET
SET
Knob
SET
Integral Time
Push down for 5s
Turn clockwise/
counter-clockwise
Push down
Push down
SET
Derivative Time
Knob
SET
XXXX
d
SET
Damp Constant
SET
Push down
d
10
SET
XXXX
i
Push down
oth
40
Knob
Push down
XXXX
souf
SET
ot
SET
filt
Proportional Constant
XXXX
p
SET
SET
Initial
125
60
10
40%
i
60
Parameter Display
Operation Mode
Range
0-999
0-999
0-999
0-100
233
450
Lck
0
Table 1. Parameters in RDK-100/110 under access code “0036”.
Symbol Display
Symbol Display
p
P
I
I
d
d
OTH
oth
Cycle Rate
SET
XXXX
Digital Filter Strength
Figure 2. Flow chart of how to change the parameters under code 166.
SET
XXXX
end
Figure 1. Flow chart of how to change parameters under code 0036.
3. For RDK-200/300
Press and hold the knob down for 5s, then enter access code “166”, press
knob once again to confirm. You will enter parameter setting mode. For 100W
Coil, you need to set OTH value to 100%. Other settings should remain
unchanged. Please see Table 2. For 250W Coil, you need to set OTH value to
40% (default value). Please refer the flow chart in Figure 2 for details.
2015.04
Auber Instruments Inc.
5755 North Point Parkway, Suite 99,
Alpharetta, GA 30022
www.auberins.com
E-mail: [email protected] Tel: 770-569-8420
P1/1