ControlLogix®/Studio 5000™ Studio 5000 Logix Designer™ Level 2: Basic Ladder Logic Programming June 4-5, 2015 Thursday –Friday 8:00am-4:30pm Location: Brohl & Appell, 140 Lane Street, Sandusky Course Number: CCP151 Course Purpose This course is a skill-building course that provides you with the resources and hands-on practice required to program basic ladder logic instructions for any Logix5000™ controller. You will have an opportunity to use the Studio 5000 Logix Designer™ application to perform basic software tasks to meet the requirements of a given functional specification. In addition, you will set up a sequencer to run equipment through a predefined procedure and separate production procedure from equipment control. To Register Course Agenda             Day 1 Starting a Ladder Diagram Testing a Ladder Diagram Programming Timer Instructions Programming Compare Instructions Programming Move Instructions Programming Math Instructions Day 2 Programming Counter Instructions Handling Expressions Documenting and Searching Ladder Logic Programming a Procedure Separating the Procedure from Equipment Control Copying and Filling an Array To register for this course, contact Brohl & Appell at 419-625-6761 or 800-4720313 by May 20th. Seating is limited. Cancellations must be received no later than May 27th or a 50% penalty for cancellation will be charged. No shows will not be issued a refund. Cost of Program $1240.00 per attendee. Please call for multiple attendee price plan. Lunch will be provided. Student Materials To enhance and facilitate your learning experience, the following materials are provided as part of the course package: • Student Manual • Studio 5000 Logix Designer and Logix5000 Fundamentals Procedures Guide • Logix5000 Documentation Reference Guide Hands On Practice Throughout this course, you will have the opportunity to practice the skills you have learned through a variety of hands-on exercises. These exercises focus on the skills introduced in each lesson. IACET CEUs Awarded: 1.4