1. No category

HOW TO CUT A KATZ DISPLAY BOARD
The best results we achieved were with a static knife, an oszillating knife and with die cutting.
To cut KATZ DISPLAY BOARD only half through the cutting knife must be set on -0.5mm from the bottom of the board.
board thickness
half through cut
0.5mm
through cut
We use a ZÜND M250 cutter, the setting may vary when using other cutting machines.
HOW TO FOLD A KATZ DISPLAY BOARD
1. Half through Cut: The best results we achieved were with a static knife & an oszillating knife.
folding:
fold the cutted side,
but not more than 90°
cut
top layer
inner core
90°
bottom layer
setting: -0.5mm
2. V-cut: The best results we achieved were with a static knife.
If you want to fold it to the other side to cover the edges you can use this cut.
folding:
fold the cutted side,
but not more than 90°
cut (45°)
top layer
90°
inner core
bottom layer
setting: -0.5mm
3. V-cut with gap: For this cut you need a router.
If you want to fold it to the other side to cover the edges or to fold it more than 90° you can use this cut.
folding:
fold the cutted side,
more than 90° possible
routing (45°)
top layer
< 90°
inner core
bottom layer
setting: -0.5mm
it is important to have a
small horizontal cut here
The specific settings need to be tested for each machine and thickness.
KATZ GmbH & Co. KG
Hauptstr. 2 | 76599 Weisenbach | Deutschland | Fon + 49 7224 647 0 | Fax + 49 7224 647 10 165 | office@ thekatzgroup.com | www.thekatzgroup.com
Bankverbindung: Baden-Württembergische Bank | BLZ 600 501 01 | Kontonummer 4520311 | IBAN DE67600501010004520311 | SWIFT SOLADEST
Sitz: D-76599 Weisenbach | Amtsgericht Mannheim HRA 702678
P.h.G.: Katz GmbH | Sitz: Oberkirch | Amtsgericht Freiburg i.Br. HRB 704730 | Geschäftsführer: Daniel Bitton, Kai Furler
Kommanditistin: Papierfabrik August Koehler SE | Sitz: Oberkirch | Amtsgericht Freiburg i.Br. HRB 709115 | Vorstand: Kai Furler (Vorsitzender), Frank Lendowski, Werner Ruckenbrod