Cleaning Hints And Tips... Try to treat spot stains before they are allowed to dry. Close zips and button garments before tumbling. Clean similar fabrics together. Dry-Clean Only is not recommended for heavily soiled fabrics, dried-in stains, previously treated or large stains. Remove garments immediately after tumbling. Shaking before hanging helps prevent creasing. Other Information... COLOURFAST TEST Use one Dry-Clean Only sheet to thoroughly moisten an inconspicuous area of the garment. Press a clean white cloth onto the treated area. If any colour appears on the cloth, the garment is NOT colourfast. DO NOT proceed with spot stain treatment. Dry-Clean Only sheet may still be used for freshening. If original colour or pattern remains unchanged, proceed with the full application following the instructions on the pack. TUMBLE DRYER SETTING Before use, dryer must be cool and lint filter cleaned. For dryers with no low/delicate heat setting set dryer for 10 minutes, leave dryer to cool then,tumble for a further 10 minutes. N.B. Washer dryers can be used, but DO NOT use wash cycle. Dry-Clean Only DIRECTIONS FOR USE it works because we care about cleaning... Dr. Beckmann Dry-Clean Only helps you prolong the time between trips to the dry cleaner by removing everyday stains and refreshing dry clean only fabrics easily and conveniently at home - in your tumble dryer. This can save you hundreds of pounds in cleaning bills. Clean... Refresh... STEP ONE – THE COLOURFAST TEST Having read the important information panel on the side of the pack, you must always pre-test all coloured areas in an inconspicuous area first. Dab the cloth on to the fabric and then proceed to dab the treated area with a moist white cloth. If any colour is seen on the cloth, do not continue. Remove any residues of solution with a clean damp cloth. STEP TWO Place a clean white cloth or paper towel under the stained area and dab the stain with the Dry-Clean Only sheet, working the solution into the stain and pushing it through onto the cloth. STEP THREE Use fresh areas of the cleaning sheet as may be required to treat the stain completely. Keep turning the cloth underneath and use clean area to absorb the stain until it’s removed. STEP FOUR It’s important to finally blot excess cleaning fluid from the garment with a clean damp cloth to remove any residues and avoid rings. (Having firstly removed visible spots and stains from your garments, if required by following the spot cleaning instructions). STEP ONE Clean tumble dryer lint filter thoroughly. Close any buttons and zips and turn fragile trims (including beads and sequins) or buttoned garments inside out. Then place 1 to 4 garments or items of similar fabric, weight and colour into the dryer. Garments should have room to move - do not overfill. STEP TWO Use either the same cleaning sheet used for spot stain removal or a new fully opened Dry-Clean Only sheet and place in the tumble dryer with the garments. STEP THREE Tumble on low heat or delicate setting for 20 minutes on a timed setting not counting the cool down time. STEP FOUR Remove garments from dryer immediately after the cycle has stopped. Shake lightly then hang to prevent creasing. Garments are ready to wear though some items may require light ironing (always check garment care label first). The Dry-Clean Only sheet should be discarded after use.