Instruction Manual

www.wakecup.in
For Feedback or Queries, Please Contact:
Email: [email protected] Tel.: 1860 425 3399
Instruction Manual
01
IMPORTANT SAFEGUARDS
When using electrical appliances, the following basic safety precautions
should always be followed:
1. Read the instructions carefully.
2. Before connecting the appliance to the power supply, check that the
voltage indicated on the appliance corresponds with the voltage in
your home. If this is not the case, contact your dealer and do not use
the kettle.
3. To protect against electrical hazards, do not immerse cords, plugs or
the appliance in water or any other liquid.
4. Close supervision is necessary when any appliance is used by or near
children.
5. Do not operate the appliance without anything in it to avoid damaging
the heat elements.
6. Unplug from the power supply when not in use and before cleaning.
7. Allow to cool before assembling or removing the parts, and before
cleaning the appliance.
8. Do not operate any appliance with a damaged cord or plug or if the
appliance malfunctions, or has been damaged in any manner.
9. Do not use outdoors.
10. Do not let the plug hang over the edge of a table or counter, or come
into contact with hot surfaces.
11. Do not place near a hot gas or electric burner, or in a heated oven.
12. Ensure that the appliance is used on a firm and flat surface out of
reach of children, this will prevent the appliance from overturning
and prevent damage or injury.
13. Keep hands and utensils out of container while blending to reduce
the risk of severe injury to persons or damage to the blender.
14. Extreme caution must be used when moving the appliance.
15. Always attach the cord to the appliance first, then the plug to the
power supply.
16. CAUTION: This appliance generates heat during use. Proper
precautions must be taken to prevent the risks of burns, fires or any
other damage to people or property.
02
18. This appliance is for household use only. Do not use the appliance for
anything other than its intended use.
19. To reduce the risk of electric shock, heat milk only in the removable
stainless steel jug.
20. If the power supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similar gratified person in
order to avoid a hazard.
21. This appliance has been incorporated with a grounded plug. Please
ensure the wall outlet in your house is well earthed.
22. The appliance only used for frothing and heating milk. Do not use
the appliance for other than intended use.
23. Always operate the appliance with cover in place.
ENVIRONMENT
.
.
If you wish to dispose the appliance, remove the plug from the wall
socket, and cut the power cord. Keep the appliance and its parts out of
reach of children. Take the unit to an approved collection point for
small electrical appliances.
Dispose of packaging materials such as plastic and cardboard in
appropriate containers.
DISPOSAL
DESCRIPTION OF THE MACHINE
Please dispose of old machines in an environmentally neutral way.
Old machines contain valuable materials which should be salvaged for
recycling. Please therefore dispose of old machines via your regional
collection system.
Lid arm
Agitation means
Stainless steel
inner layer
Handle
Cordless jug with
non-stick coating
On button
Powerbase with cord
07
Power plug
06
CAUTION
Do not immerse the appliance in water or other liquids. There is a danger
of electric shock.
Do not use any aggressive or abrasive cleaning products, or any sharp
objects (such as knives or hard brushes) when cleaning.
TECHNICAL SPECIFICATIONS
Power:
570 -630W
Main Voltage:
220-240V 50Hz /60Hz
Capacity:
160ml for Milk frothing /260ml for Milk Warming.
Dimensions:
L 160mm × W 120mm × H 200mm
03
OPERATING INSTRUCTIONS
A. Frothing milk
Use the frothing attachment to create a dense and creamy froth for
topping your cappuccinos or livening up your instant coffees.
.
.
.
.
.
Pour milk (80C-120C) into the jug between the minimum mark and
the 160ml mark, DO NOT FILL ABOVE THE 160ML MARK.
Place the lid on the jug until the two arrows " " meet and the lid is
locked in place.
Connect the machine with power and ON button will light up with red
colour, push the ON button to start frothing, ON button will be in
blue colour. It will take 70-90 seconds.
When the temperature reaches 65 + 100C, the machine will stop
automatically and blue light goes out, the red light will turn on.
To open, lift the lid, pour the frothed milk on your coffee and serve.
IMMEDIATELY rinse with water and wipe clean after each use.
B. Heating milk
.
.
.
.
.
Fill with milk (80C-120C) between the minimum mark and the
260ml mark, DO NOT FILL ABOVE THE 260ML MARK.
Place the lid on the jug until the two arrows " " meet and the lid is
locked in place.
Connect the machine with power and ON button will light up
with red color, push the ON button TWO TIMES to start heating
milk, ON button will be in blue color. It will take 70-90 seconds.
When the temperature reaches 65 + 100C, the machine will stop
automatically and blue light goes out, the red light will turn on.
To open, lift the lid, pour the frothed milk on your coffee and serve.
IMMEDIATELY rinse with water and wipe clean after each use.
04
C. Frothing milk in cold
.
.
.
.
.
0
05
12. TROUBLE SHOOTING
0
Pour milk (8 C-12 C) into the jug between the minimum mark and
the 160ml mark, DO NOT FILL ABOVE THE 160ML MARK.
Place the lid on the jug until the two arrows " " meet and the lid is
locked in place.
Connect the machine with power and ON button will light up in red
colour, push the ON button THREE TIMES to start and blue light
will flash.
SYMPTOM
CAUSE
CORRECTIONS
When frothing,
milk goes out from
the jug.
Milk poured in the
jug is over the
maximum mark.
Stop the machine
and clean the
machine, operate
the machine
according to
instruction manual.
After starting the
machine, motor
works but frothing
device does not
work.
The lid is not closed
properly on the jug.
Press the lid until
the two arrows
meet, then the
machine will
function normally.
After the machine
starts working, the
blue light flashes.
After continuous
use of machine, the
inner temperature
rises. The blue light
indicates the same.
Let it cool down or
pour cold water
inside to reduce
temperature.
The machine will
function normally
again.
When the cold frothed milk is ready, the machine will stop
automatically. The blue light goes out, the red light will turn on.
To open, lift the lid, pour the frothed milk on your coffee and serve.
IMMEDIATELY rinse with water and wipe clean after each use.
CLEANING AND CARE
Remove jug from powerbase before cleaning. Never immerse jug, base or lid
in water or use an abrasive cleaner.
1
Clean IMMEDIATELY after each use. Flush out and clean the walls using
water and a non-abrasive cloth. Then dry with a soft cloth.
2
Wipe clean with a damp non-abrasive cloth,
DO NOT IMMERSE THE JUG OR POWERBASE IN WATER.
3
Clean the froth device with water.
4
A layer of milk may stick to the bottom of the jug, if not removed and left
to dry, it can be harmful. Always wipe off with a non-abrasive cloth.
5
Never immerse jug, base in water. Wipe clean with damp non-abrasive
cloth.
6
Never use sharp objects or an abrasive scourer pad; it will damage the
non-stick coating.