1. No category

CALT10070.pdf 1 13/12/2013 3:31:22 PM
CAL-T10070
Professional Installer Highly Recommended
The manufacturer will not warrant any faulty installations,
and damage to existing structures or any other
fixtures / fittings as a result of incorrect installation.
STEP 1
FIXED TV WALL BRACKET
STEP 2
Mount bracket to wall.
Select a position for the wall bracket (1). If screwing into a
plasterboard wall, use a stud finder to locate a beam behind
the plasterboard to secure to. If fixing to a concrete/brick
wall, we recommend the use of plastic wall anchors
(9). Using the wall bracket as a stencil, hold the
wall bracket in position and use a pencil
through the screw holes to mark the
locations on the wall for drilling. (See
Additional Tools required section for
drill bit sizes) Affix to wall using
wall screws (8).
Mount railing to TV.
Locate screw fixtures in the back of your TV and attach railings (2)
using the screws provided.
The screw size required will vary on each TV so we have provided
you with a range to choose from (M6, M8).
1
Optional: Insert spacers if back of TV is not a flat.
2
8
IMPORTANT: PRE-DRILL HOLES
Make sure bracket is secured to joists,
or anchors are used for concrete.
STEP 3
Position mount over bracket.
Once the railings (2) are firmly
C
attached to the TV hook the railings
onto the wall bracket (1).
M
1
If setting the viewing angle at 0° then
attach the fixed plate A (4) at the
bottom of the railing (SETUP A) and
secure with the screwss provided.
Y
CM
MY
If setting the viewing angle at 5° then
no support bracket is needed (SETUP B).
CY
CMY
B
K
H I G H C A L I B E R WA L L M O U N T I N G S Y S T E M S
4
5° 0°
7
STEP 4
A
2
Fasten mount to bracket.
Slide the locking bar (3) through wall
bracket (1) guide holes and holes in
both railings (2) to secure them
into place. Use locking pin (5) provided
to secure locking bar.
5
3
DISTRIBUTED BY RVM AUSTRALIA t: (08) 9417 9944 e: [email protected]
Nov 2013
CALT10070.pdf 2 13/12/2013 3:31:23 PM
CAL-T10070
ADJUSTABLE TV
WALL MOUNT BRACKET
5.
6.
8.
9.
C
PARTS DRAWN TO SCALE 1:1
M
Y
CM
MY
x4
M6
CY
x4
M8
Spring
Washer
CMY
Spring
Washer
K
x4
H I G H C A L I B E R WA L L M O U N T I N G S Y S T E M S
x4
NOTE: Use spring washers when securing bolts. This will reduce the risk of bolts coming loose.
ADDITIONAL TOOLS REQUIRED
A socket wrench will be
required wherever
you see this icon.
A drill will be required to drill
pilot holes for the arm bracket.
Masonry Wall - 9mm bit
Studded Wall - 5mm bit
A phillips head
screwdriver will be
required wherever you
see this icon.
PARTS LIST
No.
1
2
3
4
5
6
7
Part
Wall Bracket
Railings
Locking Bar
Fixed Plate A
Locking Pin
Washer
M5 x 7mm Screws
Qty
1
2
1
2
1
8
4
No.
8
9
Part
Wall Screws
Wall Anchors
Qty
8
8
DISTRIBUTED BY RVM AUSTRALIA t: (08) 9417 9944 e: [email protected]
Nov 2013