HOW TO INSTALL A WING MODEL USING LOD EDITOR 6.23 BY JANHAS LOD Editor 6.23 is available via my website (bms page). The process of installing a wing model (you look at when you look from inside the cockpit to the wings) is the same as with external models. The problem is that there is no CT# (model number) or name to be found in the list. You have to manually type in the wing model number. The wing models name end with 4 numbers. That is the model number. The list with cockpit numbers can also be found here: \Falcon BMS 4.32\Docs\Other Documentation\Database\Cockpit_parents.xls. For this example I will use the F-16 block 50CJ wing model. I will skip the steps of installing and opening the LOD database. Check the "Model_Install_with_LE623.pdf" manual for help if you don't know how to do this. It's available via my website too (bms page). 1. When you are in the main screen click once on model number 0 (CT# 0) (1). A bar will appear. On the lower right you will see the "Parents" section with all 0's. Manually change the 0 on the right of the "Normal" button to 1196 (2). (If you want to see if you have the right model click then on the 3-D viewer button). When the number has been entered you click on the "Normal button" (3). 2. You are now in the LOD-Parent Data screen. You will see that there is only one model to replace. Now adjust the data using the Parent_Data_Wing jpg. The data to be adjusted are marked in green (4). Click on the "Update" button when you are done editing the data (5). More then once I have adjusted the number of skin sets a model uses, so check it!. The skin set number has to be the same for the internal and external models. 3. Replace the wing model. It's done in the same way as with external models. (cycle to "Replace Mode" (6), "1" button (7), select model (check model numbers!), ok). When you have replaced the model you go back to main LE screen or exiting LE using the "Goto" button (8). The process for replacing all of the wing models is the same for all wing models. If you have problems check the "Model_Install_with_LE623.pdf" manual or e-mail me via [email protected]