Anterior Staple Plates. Spiked washers for anterior dual screw/dual rod constructs for use with any monoaxial screw system. Technique Guide Table of Contents Introduction Overview 2 Indications 2 Surgical Technique 3 Warning This description is not sufficient for immediate application of the instrumentation. Instruction by a surgeon experienced in handling this instrumentation is highly recommended. Synthes 1 Overview and Indications Overview The Anterior Staple Plates – work with any monoaxial screw system, – provide increased rotational stability, – provide increased correctional strength and – facilitate screw placement. The Anterior Staple Plates are made of Titanium Alloy (TAN) and are available in three different sizes: For use with ⭋ 5.2 mm screw or smaller. Plate width: 15 mm Plate length: 21 mm For use with ⭋ 6.2 mm screw or smaller. Plate width: 16.5 mm Plate length: 23 mm For use with ⭋ 7.0 mm screw or smaller. Plate width: 18 mm Plate length: 25 mm Each staple plate size is available with three different hole configurations: Orientation of holes: Parallel Orientation of holes: Inferior Indications – Spinal deformities (congenital, idiopathic, neuromuscular) – Tumors – Fractures – Degnerative diseases 2 Synthes Anterior Staple Plates Technique Guide Orientation of holes: Superior Surgical Technique 1 Determine staple plate size Instruments 03.660.002 Trial Implant for Staple Plate, for Screws ⭋ 5 mm 03.660.004 Trial Implant for Staple Plate, for Screws ⭋ 6 mm 03.660.006 Trial Implant for Staple Plate, for Screws ⭋ 7 mm Use the trial implants to select the appropriate staple plate size. 2 Assemble inserter Instrument 03.650.000 Inserter for Staple Plate Slide the threaded inserter shaft into the cannulated inserter instrument and turn it clockwise. 3 Capture staple Align the inserter with the staple plate and turn the inserter shaft clockwise to secure the plate. Synthes 3 4 Seat staple plate Drive the staple plate spikes through the cortical bone of the vertebral body. Seat the plate by striking the inserter with a small mallet. 5 Assemble construct Complete the construct with any monoaxial screw system with rods. Pangea Monoaxial screws were used for construct shown in picture Note: The screw length chosen should achieve a bicortical purchase. 4 Synthes Anterior Staple Plates Technique Guide Presented by: 036.000.930 SE_086727 AA Ö036.000.930öAA†ä 50060073 © Synthes 2007 Subject to modifications
© Copyright 2024