1. No category

564 IronWorks Face
Installation Instructions
Compatibility
IronWorks Face – With Barrier (new) 95400434
 564 SS/DF/DLX w Barrier (2014 or Later)  564 HO GS w Barrier (2014 or Later) IronWorks Face – Non‐Barrier (old) 95400432
 564 SS/DF/DLX (no barrier)  564 HO GS (no barrier) Packing List





Faceplate Upper and Lower Grills Doors (Left and Right) Glass Frame Cover (6) #8 x 3/8” Sheet Metal Screws Sizing
Faceplate
Width 36 1/8”
Height 29 1/8”
Depth on Hearth ½” *
* This dimension is the minimum depth. The face may be positioned to accommodate different facing depths, making this dimension up to 1” larger. Installation
1.
Carefully remove the packaging and lock‐ties from the faceplate and doors. Remove the glass frame from the fireplace (see the Owner’s Manual for details). Attach the glass frame cover to the glass frame following the directions below. Place the cover over the top of the door frame.
Push these tabs inwards
to lock the cover in place.
Page 1 of 4
17601658 — 10/23/14
© Travis Industries, Inc.
564 IronWorks Face
Installation Instructions
2.
Attach the faceplate to the fireplace as shown below. Slide the face into place and
secure with the six included
screws.
NOTE: These slots are provided to allow the
face to be installed off of the fireplace when
using tile or other non-combustible facing.
Careful front to back and side to side
alignment is required to ensure proper door
alignment.
Page 2 of 4
17601658 — 10/23/14
© Travis Industries, Inc.
564 IronWorks Face
Installation Instructions
3.
Hang the grills included with this face on the fireplace. Upper Grill Installation
Hold the grill at a slight angle and insert it behind
the face and in front of the bushings on the
fireplace.
Line up the upper slots on the grill with the upper
bushings on the fireplace. Push the grill in, then down
until the grill locks into place.
Place the FPX label onto this plate
before shutting the grill.
Lower Grill Installation
Hold the grill at an angle and insert the lower
slot over the bushing on the fireplace (both
sides). You may need press on the grill to get
the tab over the bushing (this prevents the
grill from accidentally falling off).
Page 3 of 4
Bend the tab outward on
both sides. This is the
end-stop for the lower grill,
it allows the grill to swing
forward.
17601658 — 10/23/14
Swing the grill upwards to engage
the upper slot. You will need to lift
the grill slightly to get it over the
bushing. Once in place the grill is
held in place by gravity.
© Travis Industries, Inc.
564 IronWorks Face
Installation Instructions
4.
5.
Attach the glass frame to the fireplace. Install the doors as shown below. When closing the doors, make sure to bring them together at the same time to ensure proper alignment. NOTE: Magnets are shipped attached to the face. Take care with the magnets and keep them away from children. NOTE: If the magnets become dislodged from the position in the faceplate, carefully re‐install them. Page 4 of 4
17601658 — 10/23/14
© Travis Industries, Inc.