1. No category

A revolution
in security
easy
mounting
Remove the old thumb turn on your Click the lid off your danalock with your
door, but please keep the screws that nails, or loosen the lid by gently turning
held it for later use.
a screwdriver in the slot at the rim of
the shell.
The danalock comes with batteries inserted, but a thin plastic folio
guarantee that your new danalock is fully charged. Remove the folio
and the danalock lits up with a green light for 5-10 seconds.
10 mm
Loosen the 3 base-screws placed right underneath the printed circuit board with
a screwdriver.
Now fasten the baseplate
with the screws that original
ly held the thumb turn and
cylinder piece.
Place your danalock on the base, be
sure the cylinder tailpiece fits in the
center.
poly-control International Aps
Gammel Stillingvej 427 C . DK - 8462 Harlev
+45 4242 8122 . www.poly-control.com
Important! The cylinder tailpiece must not stick out more than 15
mm from the door. An easily adjusable tailpiece is included.
Fasten the 3 base-screws.
Click the lid back on. Now Your
danalock is now ready for use.